User manual US ROBOTICS USR8000A-02 INSTALLATION GUIDE

[. . . ] Robotics 4-Port Broadband Router can easily be connected to any Ethernet-based cable modem or DSL modem, or an RS-232 based analogue or ISDN modem. You can verify compatibility by checking to see if your cable or DSL modem is connected to the network adapter in your computer using an Ethernet cable. Connect your 4-Port Broadband Router to your computer and power supply 4-Port Broadband Router 4-Port Broadband Router Broadband Router Quick Installation Guide Package Contents Connecting the 4-Port Broadband Router one (1) Ethernet cable Note: For the most updated information, visit: http://www. usr. com/suppor t http://www. usr. com/support . usr. com/suppor You can also refer to the User Guide on the U. S. Robotics Installation CD-ROM for more detailed information. cable or DSL modem 4-Port Broadband Router 5VDC power supply Quick Installation Guide Installation CD-ROM Prepare for installation Note: Your product number is 8000-02. [. . . ] If Universal Plug and Play does launch, follow the onscreen instructions accordingly. If Universal Plug and Play does not launch, follow the procedures below. Cable or DSL modem users: · Turn off your PC and your cable or DSL modem. · Locate the Ethernet cable that connects your cable or DSL modem to your PC's Ethernet adapter. · Disconnect that Ethernet cable from your PC's Ethernet adapter, and connect it to the WAN port on the rear of the 4-Port Broadband Router. cable or DSL modem Launch a Web browser. In the location or address line of your Web browser, type http://192. 168. 123. 254 to access the Configuration Utility. There is no default password for the 4-Port Broadband Router, so just click Login Click P rimar y Setup Change and ogin. rimary Setup Change, etup, then select your WAN type. Depending on your WAN type, you may need to supply some connection information. When you are finished, click Save Save. 4-Port Broadband Router Rear View Port Printer COM WAN L AN ports 1-4 Function To attach a printer to the Local Area Network To connect an analogue or ISDN modem RJ-45 port to connect a broadband modem To connect devices to the Local Area Network Analogue or ISDN modem users: · Turn off your PC and your analogue or ISDN modem. · Locate the serial modem cable from your analogue or ISDN modem that is connected to your PC's serial port. · Disconnect that serial modem cable from your PC's serial port, and connect it to the COM port on the 4Port Broadband Router. analogue or ISDN modem Note: Refer to the "Configuring the 4-Port Broadband Router" section in the User Guide for more detailed configuration information. Contact your ISP if you have any questions about your WAN type or your connection information. Congratulations!The installation procedure is now complete. Cable or DSL users: You should now have secure and shared Internet access. To verify your connection, launch a Web browser and register your product at www. usr. com/ www. usr . usr. com/ prdouctreg If the page loads, you are finished with the installation procedure. If the page does not load, proceed to the Troubleshooting section in the User Guide on the U. S. Analogue or ISDN users: You should now have secure and shared Internet access. [. . . ] While holding the RESET button, plug in the power supply. When the 4-Port Broadband Router has power again, continue to hold the RESET button until the SYSTE M LED begins flashing. This will reset the 4-Port Broadband Router to the factory default settings. Reset Note: If your cable, DSL, analogue, or ISDN modem is connected to your PC using a USB cable, disconnect the USB cable from both your PC and from your modem. [. . . ]