User manual VARIZOOM VZ-EFC

[. . . ] 4) Replace the screw in the motor spindle. 1 2 3 1 4 See the above pictures for an idea of how to attach the assembly to a standard Canon or Fujinon lens, but please read the rest of the instructions before continuing. -IF you have one of the smaller Fujinon lenses (S14x7. 3, S16x7. 3, S12x5, A12x6. 8), you will have to make one small change (see pictures below). The aluminum bracket that screws onto the lens barrel (A) comes oriented to fit standard Canon and Fujinon lenses, but to make it fit the smaller Fujinon lens you will have to remove it and flip it around (note that one side of the bracket has a slightly smaller arc ­ this will be the side facing the barrel of the smaller lens). Loosen the black tee-head screw that fixes the bracket to the stainless steel rod and slide the bracket off the rod (see picture 1 on previous page). [. . . ] You will notice that the individual arms of the motor bracket assembly can be positioned by loosening the plastic tee-head screws. Position the gear so that it is near the front of the ridges on the focus ring when it is set to infinity (or in the middle of the focus ring if your lens has internal focus / "Innerfocus"). Once the gear has been mated to the focus ring, you can turn the dial on the control unit to adjust the lens through the focal range (1300 to 0 on the LCD readout). PROGRAMMING FUNCTION You can program up to 4 sequential focal stop points. To program your stop points, hit the SCROLL button until you are in `Mark' mode, and then hit the SELECT button. You will see "A" come up, and you should turn the dial until you reach the desired focal point that you want to mark as "A". Hit the SELECT button to set the focal point. Hit the scroll button to get to "B", turn the dial to the desired focal point you wish to mark as "B", then hit SELECT. Repeat the same process for additional marks. If you only wish to mark 2 focal points, then after marking "B" hit SCROLL until you reach "EXIT" and push SELECT. Once you hit "EXIT", the control unit is back in operating mode. Hit the SELECT button to shuttle between the marks in sequence. Hit the SCROLL button once to go back to full range mode (manual), and hit it 3 times to go back through the menu to reset your marks. BATTERY CHARGING You can check remaining capacity of the battery by pushing the button next to the row of indicator LEDs. [. . . ] NOTE: Do not attempt to remove battery from main unit. NOTES You should turn off the control unit when not in use. Do not expose the motor or control unit to water or excessive heat. The VZ-EFC is covered by a 2-year warranty (parts/labor) against defects in materials or craftsmanship. [. . . ]