User manual VDO CYCLECOMPUTING C05

[. . . ] Accurately position the spoke magnet and the sensor first, then tighten the cable ties. 3 GB 1. 3 Mounting the spoke magnet Distance between magnet and sensor should be approx. 1-5 mm. 1-5mm In case this distance is not achievable in the current positioning, slide the sensor and the magnet on the fork or spoke accordingly. 4 1. 4 Installing battery into computer head To save battery power, your VDO CYTEC C 05 comes with the battery not yet fitted. Prior to initial use you have to install the battery first. Insert battery with positive (+) end on top. [. . . ] The figure measured (in mm) is the wheelsize to be entered into your computer. 10 Watch out: In case you have selected MPH readout you must enter your wheelsize in mm. GB 1x WS in mm 11 GB 5. 3 Entering your wheelsize / entering odometer After initially installing the battery or after a battery change, your VDO CYTEC C 05 automatically switches into set-up mode for wheelsize and odometer. You might as well enter the set-up mode for wheelsize and odometer at any time by proceeding as follows: Step 1: Call ODO information in your display. Display shows an alternating flashing symbol for KMH and MPH. Step 3: By pressing the MODE button you can choose whether you want MPH or KMH readout on your display. Now you have determined whether your VDO CYTEC C 05 is either measuring in kilometers or miles. Step 4: Once you have chosen your measuring unit, the wheelsize value is displayed. After a battery change, the default value (2124) comes up. In case you have entered wheelsize set-up from ODO (see step 1), the last value entered will come up. In case you want to use the default value (2124) after a battery change, just press the MODE button within 2 seconds. The default is then automatically set up and the computer returns to regular mode. In case you wish to enter the precise wheelsize you have measured yourself (i. e. 12 Step 5: Not pressing the MODE button with in 2 seconds will make the last digit (2124) flash and change the value (4-5-6-7. . . ) Once the correct digit (7) comes up, press the mode button. Now the third digit GB flashes and changes its value (2127). Once the correct digit (5) comes up, press the mode button. Next to flash is the second digit (2157). Once the correct digit (2) comes up, press the mode button. Next to flash is the first digit (2257). Step 6: When the wheelsize is completely entered, the computer automatically changes into set-up mode for odometer value. Here you enter your previous totals after a battery change. In case you do not wish to enter an odometer value, press the MODE button five times. There by you exit the set-up mode and the computer returns to regular display. For entering an odometer value, wait for the last digit to flash (12345) and automatically change its value. [. . . ] does not appear between sensor and magnet cable from sensor to computer check cable and replace if necessary. head broken computerhead is incorrectly place computerhead on handlebar holder and twisted on handlebar holder twist until detent (CLICK) no wheelsize entered enter your wheelsize display fades battery in computer empty check battery power and replace it if necessary. or disappears temperatures below 5° C (40° F) back in normal temperatures, display picks up dull display readout working correctly. Warranty We warrant VDO CYTEC models (sensor, computer head and handlebar holder) to the original purchaser for five years from date of purchase against defects in material and workmanship. [. . . ]