User manual VELODYNE SC-ICG INSTALLATION REV A

[. . . ] Wall or Ceiling Mounting -- The product should be mounted to a wall or ceiling only as recommended by the manufacturer. Ventilation -- The product should be situated so that its location or position does not interfere with its proper ventilation. For example, the product should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or placed in a built-in installation such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. [. . . ] Do not connect the 120-volt version to 230-volts or vice-versa. This will result in damage to the subwoofer and possible injury to the user. CAUTION: To prevent electrical shock, match wide blade of plug to wide slot, fully inserted. SC-ICG (In-Ceiling Grille) User's Manual 9. 21. . www. velodyne. com 1 i Congra ng a e ons R e s t o r i t u l Dt ifa u l t s Congratulations on your purchase of a Velodyne in-ceiling grille. The Velodyne in-ceiling grille is for use with the SC-IF/IC (In-Floor/In-Ceiling) or SC-600 IF/IC subwoofers. Read and follow this instruction manual to ensure safe and proper installation. Prior to Installation Please unpack the grille carefully. Please save the carton and all packaging materials for Warning Before installing the Velodyne in-ceiling grille, have the subwoofer location established. Avoid rafters, pipes and cabling when installing sub and grille. Please refer all service questions to your authorized Velodyne dealer. Remember to perform all installation procedures with system power turned off to prevent possible damage. Tools Needed · · · · · · · Drill or Phillips screwdriver Phillips drill bit (if using a drill) Box knife Staple gun Sheetrock saw Paint applicator Paint . www. velodyne. com SC-ICG (In-Ceiling Grille) User's Manual 1 I n s ta l l a t i o n I n s t r u c t i o n s Retrofit 1. Determine the center position for the subwoofer installation location. Puncture a small hole through the ceiling material at the corresponding driver center location. Figure 1. Position the SC-600 In-Ceiling template on desired installation location. 3. Center the SC-ICG cut-out template to the hole created in the previous step. . www. velodyne. com SC-ICG (In-Ceiling Grille) User's Manual 2 4. Cut the ceiling material along the solid line noted on the template, following the outer diameter of the circular template. Figure 2. Cut ceiling material along specified solid cut-line. . www. velodyne. com SC-ICG (In-Ceiling Grille) User's Manual 3 5. Insert the paint template into the in-ceiling grille basket. Paint the grille basket flange to match decor. [. . . ] This warranty is nontransferable under any condition. and Canada voids this warranty. 2. 3. 4. 5. 6. TO OBTAIN SERVICE Information regarding service may be obtained from the dealer from whom you purchased the unit, or by contacting VELODYNE customer service. [. . . ]