User manual VELODYNE SERVO F-1000

[. . . ] Carts and Stands -- The subwoofer should be used only with a cart or stand recommended by the manufacturer. Wall or Ceiling Mounting -- The subwoofer should be mounted to a wall or ceiling only as recommended by the manufacturer. Ventilation -- The subwoofer should be situated so that its location or position does not interfere with its proper ventilation. For example, the subwoofer should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or placed in a built-in installation such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. [. . . ] 1. 5". . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8" downward firing 10" downward firing Line-level & speaker-level. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Line-level & speaker-level. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . One year (parts & labor). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11. Specifications are subject to change without notice. 12. 13. DATE PURCHASED _______________________________ DEALER ________________________________________ SERIAL# ________________________________________ *NOTE: Please complete and return your warranty card within ten (10) days. 17. 1 10 signal sensing turn on/off that will automatically turn on the unit when a signal is present at the inputs and turn off the unit after several minutes when there is no longer any signal at the inputs. If you plan to leave the VA-806/907 unused for an extended period of time, we recommend that you turn off the unit by the master power switch on the rear panel. Congratulations! Congratulations on your purchase of a Velodyne VA-806/907 subwoofer system. This system represents the state of the art in accurate low frequency reproduction. Read and follow the instructions below to insure safe and proper system operation. To prevent fire or shock hazard, do not expose this equipment to rain or moisture. To avoid electrical shock, do not open speaker enclosure or amp chassis cover. Using, shipping, or otherwise storing the VA-806/907 subwoofer in any other position for an extended period of time may result in damage to the unit not covered by warranty. The VA-806/907 Subwoofer is magnetically shielded to reduce magnetic emission from its cabinet to increase the number of possible locations available for placement. However, this shielding may not be adequate for all installations. Certain types of televisions are particularly sensitive to stray magnetic fields. If your television produces distorted colors after installation of your VA-806/907 subwoofer, simply increase the distance between your television and the VA-806/907 until normal color and operation is returned. Inputs Your new VA-806/907 subwoofer is equipped with both speakerlevel and line-level inputs. Use the LINE-IN jacks when connecting your subwoofer to a pre-amp, signal processor, or line-level crossover. The FROM AMPLIFIER jacks connect directly to the speaker outputs of a integrated amplifier or receiver. Your amplifier section will notice no additional loading effects when you use these inputs because of their high impedance. Note Do not use both LINE-IN and FROM AMPLIFIER inputs simultaneously. Volume control This control allows you to balance the output from the subwoofer to the main speakers in your system. To adjust the volume, start with the volume knob indicator at the "MIN" setting. [. . . ] However, if the distance from the listening position to the subwoofer and the distance from listening position to the main speakers differs, the sound from each will reach your ears at a different time. + + - INTEGRATED AMP / RECEIVER SATELLITE SPEAKERS This control allows the signal to be delayed 180 degrees so the output of the subwoofer will blend in to that of your main speakers without any cancellation. Interconnect cables When installing your VA-806/907 using the line-level inputs/outputs, you should use standard shielded phono cables. Always keep the lines as short as practical to minimize noise. When using the speaker-level inputs/outputs, use the same quality speaker cable to your subwoofer as you run to your satellites. Auto turn on switch The auto turn on switch allows the user to bypass the auto turn on function if desired. When set in the "auto" mode with main power on, the VA-806/907 will turn itself on when an input signal is present. [. . . ]