User manual VELUX PAL

[. . . ] · If repair or adjustment work is needed, disconnect from mains supply and ensure that it cannot be reconnected unintentionally. · The plug on the mains cable is for indoor use only. · It is recommended to place a remote control in the room where the window and its electrical products have been installed. Function · If the rain sensor gets wet, the window operator automatically closes the window; however, the ventilation flap remains open. [. . . ] Press "Enter" to change to hours. Enter Back P1 --- SET TIMER --- P2 Set timer Delete timer 3 Press Press to highlight "Set timer". "Enter" to confirm your choice. Enter Back P1 P2 9 Time period 01 h 10min to choose hours. The window is now set Press to close after 1 hour and 10 minutes. Press "Enter" to confirm the setting. The display shows that the timer has been activated. 1 in Room 1 now closes after 1 hour and 10 minutes. Note: The timer can be interrupted by choosing "Delete timer" in item 3. Enter Back P1 P2 4 5 Locate the window, see section Locating and operating a product. The individual products can be identified by pressing for a short period of time. 1 Window Menu Locate 30 31 Access code You can choose a personal access code to protect the settings under the menu item Settings. The access code must consist of four digits from 0 to 9. Menu Keypad lock The keypad can be locked so that products cannot be operated without unlocking the keypad. The stop key can still be used. Locate Menu House House No. Press to highlight the Room in which the order of the individual products is to be rearranged. "Enter" to confirm your choice. Press Room 1 Room 2 Room 3 Enter Back P1 P2 ucts is to be rearranged or whether the changes made till now are to be saved. "More" to rearrange the order of more Press products. Repeat items 5-7 until the required order of products has been obtained. Press "Save" to save the rearranged product order. --- INFORMATION --- Save new order or rearrange more products Save More P1 P2 --- INFORMATION --- 4 Displays a list of the product types in Room 2. -- REARRANGE ORDER -- to highlight the product type where the Press order of the individual products is to be rearranged. Press "Enter" to confirm your choice. Window Roller shutter Awning blind Blind Enter Back 8 The display shows that the order has been rearranged. Note: The products are automatically renumbered when the order has been rearranged. Order rearranged P1 P2 34 35 Display light In standard settings, the light in the display is turned on when the keypad is activated and is turned off again after 10 seconds. If you do not want any light in the display, you can opt out of this. The example shows how to turn off the light in the display. Menu House Clearing remote control settings When clearing the remote control settings, all settings for Rooms, Zones, Groups and Programs and all personal names are deleted. The products, however, remain registered in the remote control. Room 1 No. [. . . ] Reduced power supply: The power supply to the product has been reduced. Repeater: A unit increasing the range of the remote control. SCD (Secured Configuration Device): A security device may be integrated in the system. If installed, the security device must be activated to be able to use the functions under menu item System settings. [. . . ]