User manual VENOM 6206 BLACK HAWK

[. . . ] Pay extra close attention to loose clothing, jewelry, long hair, and anything that can be caught in the spinning prop. CAUTION: A spinning propeller can cause severe injury. · The propeller and other running hardware are very sharp. Use extreme caution when working on or around these parts. [. . . ] 5) Press "Enter" to set the profile. 6) Press "Exit" twice to return to the main screen. Install 8 AA Batteries Note: For more detailed instructions, please refer to the VR3T instruction manual that came with your model. ESC SETUP The watercooled Venom 60A Pro Marine Brushless Speed Control that came in your VenomTM King of Shaves 6206 BLACK HAWK 35" RTR Electric Boat is pre-programmed from the factory. If you need to re-program it, please follow the instructions below. Program the ESC Use your transmitter to program the ESC in 4 easy steps: 1) Enter program mode 2) Select programmable item 3) Choose the new value of the selected time 4) Exit 4 ESC SETUP CONT. STEP #1. Move the throttle trigger to the Full throttle position and then connect the battery pack to the ESC. Wait for 2 seconds, the motor emits "Beep-Beep" tone. Wait for 5 seconds, the motor emits a special musical tone noting that the program mode has been entered. You will hear 4 groups of repeating "Beep" tones when you enter the programming mode. If you move the throttle to the neutral position within 3 seconds after one of the 4 tones, this tuning catagory will be selected. "Beep" "Beep-Beep" "Beep-Beep-Beep" "Beep-Beep-Beep-Beep" Running Mode Lipo Cells Low Voltage Cutoff Threshold Timing STEP #3. Choose the new value for the tuning category. Slide control rod through pivot block. 2. Apply thread lock and tighten the set screw. 3. Make sure the servo is centered before tightening set screw. INSTALLING THE ANTENNA 1. Thread the antenna from inside the hull up through the base of the antenna tube holder. 2. Thread the antenna through the antenna tube. 3. Seat the antenna into the antenna tube holder and then cover the end with the rubber cap. 4. For added security, you can use a small piece of silicone tubing to hold the antenna in place. 7 INSTALLING THE HATCH Secure the hatch by sliding the front pin into the hole at the front of the hull opening. The Hatch should drop easily down so that the magnets hold the hatch securely in place. To waterproof the hatch, use strips of clear tape to seal the lid on all four sides. BASIC CONTROLS WHEEL RIGHT WHEEL STRAIGHT WHEEL LEFT NEUTRAL THROTTLE RUDDER RIGHT RUDDER STRAIGHT RUDDER LEFT FULL THROTTLE NOTE: To avoid flipping the boat, reduce the throttle to slow the boat while turning. Use the steering dual rate to adjust the steering sensitivity. Refer to the radio manual that came with your kit for complete instructions. 8 TUNING GUIDE REPLACING/ UPGRADING THE PROP See page 6 ADJUSTING TRIM TABS The trim tabs are used to adjust the bow angle of the hull and add stability. [. . . ] Flex shaft and/or bearings are dirty. Cause 1. Clean and Regrease. Fix WARNINGS Do not hold the back of the boat when launching. The propeller is very sharp and may cause severe injury. Always disconnect the battery when working on the boat to avoid electric shock. [. . . ]