User manual VENOM VR3T

[. . . ] Trim Power Switch Antenna AUX Channel Steering Wheel VEN-8181 Thank you for purchasing the Venom VR3T 2. 4 GHz Transmitter. The VR3T 2. 4 GHz Transmitter has all of the great features of its FM predecessor including 3rd Channel Mixing, 16 Model Memory, and thumb switch activated Programmable Steering Dual Rate, with the stability and reliability of 2. 4ghz technology. With the freedom of 3rd Channel mixing, the VR3T 2. 4 has so many high-end features you won't need to look anywhere else for a 2. 4ghz transmitter. TH. Trigger NAVIGATION KEYS NOTE: Make sure the polarity of the 8 AA Alkaline batteries are correct when they are put into the transmitter. In order for these settings to be programmed into the VR3T 2. 4 the following steps must be followed. [. . . ] If TH is selected, braking only occurs on the Throttle brake. If AUX is selected, braking only occurs with the AUX channel. If TH & AUX is selected, braking occurs with both the Throttle and AUX channels. Terms: PT - Operation Trigger Point WD ­ Brake Return Amount. Sets the rate the servo returns versus trigger operation for brake release. The smaller the set value, the faster the pulse cycle. Sets the delay from brake operation to ABS. When set to 0%, the ABS function activates without delay. SM ­ Steering Mix DT ­ Cycle duty ratio. Sets the proportion of time that the brakes are being applied and released by pulse operation. Mode: Sets the channel(s) that the ABS feature will operate on. 6 2. 8 FUNCTION / MDL (MODEL) MDL - MODEL (MDL) - The Model Function used to choose one of the 16 model profiles available and create, edit and copy them as needed. SEL - SELECT 1) Press ENTER to access the model memory. 2) Use the +/- KEYS to choose a model profile. 4) Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to the Main Screen. EDT - EDIT SEL - SELECT 1) Press ENTER to access the model profile. 2) Use the +/- KEYS to select the edit menu. 3) Use the +/- KEYS to type a new name for the profile. 4) Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to the Main Screen. CPY - COPY EDT-EDIT 1) Press ENTER to access the model profile. 2) Use the +/- KEYS to choose a model profile to copy onto another selected profile. 4) Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to the Main Screen. TERMS: F-FORWARD, B-BACK, ST-STEERING, TH-THROTTLE, AUX-AUXILLIARY CPY - COPY 2. 9 FUNCTION / SPEED This function allows the speed of the Throttle Servo and Steering Servo to be set. In the Steering Speed menu, the Turning Speed and the Return Speed can be set. Steering Speed 1) Press ENTER to see the FUNCTION MENU. 2) Use the +/- Keys to select the ST function and press ENTER. 4) Use the +/- Keys to change the value. [. . . ] NOTE: This product has been tested and found to comply with the limits for a Class B digital device, compliant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy and, if not installed and used as instructed, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]