User manual VESTAX PCV-175

[. . . ] Cleaning-Do not use liquid cleaners or aerosol cleaners. Attachments-Do not use attachments not recommended by the product manufacturer as they may cause hazards. Water and Moisture-Do not use this product near water-for example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, and the like. [. . . ] If the product dose not operate normally by following the operating instructions. Adjust only those controls that are coverd by the operating instructions as an improper adjustment of other, controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. If the product has been dropped or cabinet has been damaged. When the product exhibits a distinct change in performance this indicates need for service. 16. Replacement Parts-When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original parts. Unauthorized substitutions may result in fire, electric shock or other hazards. Safety Check-Upon completion of any service or repairs to product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. Carts and Stands-The appliance should be used only with a cart stand that is recommended by manufacturer. An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. FEATURES 60mm long faders are provided for 3 program c h a n n e l s . M o r e s e n s i t ive c o n t r o l c a n b e achieved for Techno/Trance mixing. Effect send switch is equipped on each input channel for effect parformance. The effect send and return level controls are provided in the master section. (pre fader listen) switch is provided for pre fader monitoring. The input levels are monitored by over load indicator. The main mic can be assigned to program channel 2 for full control. [. . . ] 2 Remove the fader unit from position in mixer. 3 Carefully remove the multi-cable connector from fader unit. 4 Attach multi-cable connector to new fader unit. 5 Position the fader unit carefully and secure with screws. Insert the multi-cable connector CF-PCV For PMC SERIES ( PMC05ProII, PMC06ProA, etc) Set switch to "PCV" position. PMC CONNECTOR Set switch to "PMC" position 6 MIC INPUT SECTION 13 MIC INPUT JACK(MAIN MIC, MIC1 3) Input jacks for MAIN MIC, MIC1, MIC2 and MIC3. 14 MIC LEVEL Adjusts the input level of MIC1, 2 and 3. 13 15 MIC EQUALIZER(HI, LOW) Adjusts the HI and LOW frequency level of MIC1, 2 and 3. 16 EFFECT SWITCH Used to send the signal to the external effect processor connected to the effect SEND/RETURN. 14 17 P . F. L. [. . . ]