User manual VESTAX PMC-05PROIII

[. . . ] performance DJs and has become the layout New PCV Cross Fader. The new PMC-05ProIII standard for scratch and performance mixers comes standard with Vestax's latest proprietary since. Extra smooth, fast and amazingly User Replaceable Parts. It is a given that you precise, this plastic conductive volume fader is will punish your mixer enough to need to replace the built to last and survive the most intense play cross fader, an input fader and possibly the input possible. [. . . ] (See fig-a) w Remove the 2 screws which fix the switch panel, and remove the switch unit from position in mixer. (See fig-e) e Change the direction, and secure with screws. r Replace the top panel and secure with screws. qMAIN MIC LEVEL Adjusts the input level of the MAIN MIC input. wMIC EQs Adjusts the HI and LOW frequencies for both the MAIN and SUB MIC input. eMIC PAN Adjusts the panning for both the MAIN and SUB MIC. rTRIM (PGM1/PGM2) Adjusts the input level of each channel. For optimal acoustic quality, set the INPUT FADER to a position of 7 or 8 then adjust the TRIM so that a sufficient signal is fed through the channel without distorting. tPGM EQs (PGM1/PGM2) Adjusts the HI and LOW frequencies for each PGM channel. yPGM BALANCE (PGM1/PGM2) Adjusts the stereo balance for each PGM Channel. Can also be used to adjust an unbalanced stereo image. From a center position a clockwise rotation will increase the volume of channel R over L. Whereas, a Counter clockwise rotation will increase the volume of channel L over R. uCROSSFADER REVERSE SWITCH PGM channel. Reverses the action of the crossfader by switching !4 CROSSFADER PGM1 and 2. Reverse mode, when on, is indicated When the input levels of PGM1 and PGM2 are properly in the LED section. set, PGM1 will be heard with the crossfader set to the left iMASTER LEVEL VOLUME side. PGM2 will be heard with the cross fader set to the Adjusts the signal level outputs from LINE OUT. These jacks are used to connect turntables equipped with moving magnet (MM) type cartridges. Once #1 POWER SWITCH Use to turn power on. HOW TO CHANGE THE FADER UNIT q Remove the fader knobs. (See fig-a) w Remove the 4 screws which fix the top panel. (See fig-a) e Remove the 2 screws which fix the fader panel, and remove the fader unit from position in mixer. (See fig-b) r Carefully remove the multi-cable connector from the fader unit. t Remove the fader knob of new fader unit. y Attach multi-cable connector to new fader unit. (See fig-c/d) u Position the new fader unit carefully and secure with screws. FUNCTIONS TOP PANEL CONNECTION READ BEFORE OPERATING EQUIPMENT This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. 1. Read instructions-All the safety and operating instructions should be read before the appliance is operated. Retain instructions-The safety and operating instructions should be retained for future reference. Heed Warnings-All warnings on the appliance and in the operating instructions should be adhered to. Follow Instructions-All operating and use instructions should be followed. [. . . ] Overloading-Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock. Object and Liquid Entry-Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product. Servicing-Do not attempt to service product yourself as opening or removing covers may expose you to dangerrous voltage or other hazards. [. . . ]