User manual VESTAX PMC-25

[. . . ] Accessories-Do not place this product on an unstable cart, stand, tripod, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the appliance. stand, tripod, bracket, or table recommended by the manufacturer, or sold with product. Any mounting of the appliance should follow the manufacturer's instructions, and sholud use a mounting accessory recommended by the manufacturer. [. . . ] Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn. FEATURES 1. Three-band frequency isolators are provided 4. Both the input faders 60 mm and cross fader on PGM1 and PGM2. This allows DJs to 45 mm are user replaceable. The input fader can boost / cut and eliminate individual frequency be replaced with a rotary control for House ranges for active mixing. The worlds first fader-type kill switch enables 5. One Phono and two Line inputs are provided on smooth and dynamic frequency cut-off without each program channel PGM1, PGM2 . input channel has a trim control for adjusting input level. The I/O panel can be placed on either the rear or and a Mic input are also provided. This feature enables the PMC-25 to be used on the table or in a rack without any extra space for the leads. 3 FUNCTIONS PROGRAM SECTION MASTER SECTION MIC SECTION MONITOR SECTION PROGRAM SECTION 1 3 9 8 7 2 10 6 1 2 5 5 4 MID (Isolator MID) Cuts and boosts the mid frequency range. The level is flat when this knob is set at 12 o'clock. Mid frequency range is boosted up to +4dB when this knob is rotated clockwise. When the knob is rotated counter-clockwise, mid frequency range is cut off up to infinity level. For example, it can be used to emphasise or cut off the vocals or guitars. 6 INPUT SELECT (Input Select Switch) Used to select input to be sent to each PGM channel. TRIM (Trim Control Volume) Adjusts the Input level of each channel. For proper adjustment, please set the INPUT FADER to Maximum position then adjust TRIM so that the INPUT LEVEL METER shows around 0 dB at nominal level. 3 PEAK Turns on when the signal of HI, MID, LOW range hits the peak. LOW (Isolator LOW) Cuts and boosts the low frequency range. The level is flat when this knob is set at 12 o'clock. Low frequency range is boosted up to +4dB when this knob is rotated clockwise. When the knob is rotated counter-clockwise, low frequency range is cut off up to infinity level. [. . . ] The signal from the turntable is fed to the PGM channels when Phono input is selected. 28 PA OUT (Balanced Output) [XLR MALE, 2 PIN HOT] Main output jacks. Connect to the input of the power amplifier or the master console with XLR 3 pin cable. 29 PA OUT LEVEL (Balanced Output Level Select Switch) [-10dB/0dB] Used to select the output level of the PA OUT from -10dB or 0dB. Please select the level according to the input sensitivity of the power amplifier or the master console. 25 LINE 1, 2, 3, 4 [RCA PIN JACK] Connect the equipment with line level output (-10dB or 0dB), such as CD players, tape decks, DATs, MDs etc. Please refer to following Fig. Initially, the I/O panel is placed on the top-side. [. . . ]