User manual VIA TECHNOLOGIES P4MA PRO 533 VERSION 1.0

[. . . ] VIA Mainboard User's Manual VIA P4MA PRO 533 Version 1. 00 - February 12, 2003 P/N 99-51-012411 i Copyright Copyright by VIA Technologies Inc. No part of this manual may be reproduced or transmitted in any form without express written authorization from VIA. Trademarks All trademarks are the property of their respective holders. Data protection All data should be backed-up prior to the installation of any drive unit or storage peripheral. VIA will not be responsible for any loss of data resulting from the use, disuse or misuse of this or any other VIA product. No Warranty VIA has made every effort to ensure the accuracy of the content of this manual. However, it is possible that it may contain technical inaccuracies or typographical or other errors. [. . . ] Halt On Determine the system behaviour if an error is detected during bootup. Settings: All Errors No Errors All, But Keyboard All, But Diskette All, But Disk/Key System halts when any error is detected. System halts for all errors (except keyboard error). System halts for all errors (except diskette error). System halts for all errors (except disk/keyboard error) 3-6 BIOS Setup IDE Primary Master/Slave and Secondary Master/Slave Press <Enter> to enter the sub-menu and the following screen appears: The specifications of your drive must match with the drive table. The hard disk will not work properly if you enter improper information for this category. If you select Manual, make sure the information provided is from your hard disk vendor or system manufacturer. IDE Primary Slave Access Mode Capacity Cylinder Head Precomp Landing Zone Sector PIO Mode Ultra DMA Mode The settings are None, Auto, Manual. The formatted size of the storage device. The settings are Disabled and Auto. 3-7 Chapter 3 Advanced BIOS Features Virus Warning Set the Virus Warning feature for IDE Hard Disk boot sector protection. If the function is enabled, any attempt to write data into this area will cause a beep and a warning message will be displayed. CPU L2 Cache ECC Checking Set the ECC (Error-Correcting Code) feature for Level 2 cache. Facilitates error detection/correction when data passes through Level 2 cache. Quick Power On Self Test Shorten Power On Self Test (POST) cycle and enable shorter bootup time. Allow BIOS to skip some check items during POST. First/Second/Third Boot Device Set the boot device sequence as BIOS attempts to load the disk operating system. The settings are: Floppy LS120 HDD-0 The system will boot from floppy drive. The system will boot from first HDD. 3-8 BIOS Setup SCSI CD-ROM HDD-1 HDD-2 HDD-3 ZIP100 USB-FDD USB-ZIP USB-CDROM USB-HDD LAN Disabled The system will boot from SCSI. The system will boot from ATAPI ZIP drive. The system will boot from USB floppy drive. The system will boot from USB ZIP drive. The system will boot from network drive. [. . . ] [Front Speaker] panel appears and then select [Options] menu to check the item [Advanced 5-4 Appendix 3. Then [Front Speaker] panel displays [Advanced] button and press it. 4. Check the item [Smart5. 1 Enable] in the panel below. 5-5 Chapter 5 After completing the previous settings, you just have to connect your speakers to the 3 Jack Connector like shown below. Now your Smart 5. 1 capabilities are enabled. Following the system setup, users need to install software for playing DVD. [. . . ]