User manual VIA KT600

[. . . ] User's Manual VIA KT600 mainboard for AMD Socket A processor TRADEMARK All products and company names are trademarks or registered trademarks of their respective holders. These specifications are subject to change without notice. 60000028KRA10 Manual Revision 1. 0 July 14, 2003 DISCLAIMER OF WARRANTIES: THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE OF THE MANUFACTURER LIMITED WARRANTY. THE MANUFACTURER EXPRESSLY EXCLUDES ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, REGARDING ITS PRODUCTS; INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NONINFRINGEMENT. THIS DISCLAIMER OF WARRANTIES SHALL APPLY TO THE EXTENT ALLOWED UNDER LOCAL LAWS IN THE COUNTRY PURCHASED IN WHICH LOCAL LAWS DO NOT ALLOW OR LIMIT THE EXCLUSION OF THE IMPLIED WARRANTIES. Table of Contents Page Section 1 Introduction Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Onchip USB Controller Enables the USB controller. Onchip EHCI Controller Enables the EHCI (USB2. 0) controller. Options: Enabled, Disabled. Page 4-14 BIOS USB Keyboard Support Enable/disable support for USB keyboard. USB Mouse Support Enable/disable support for USB mouse. Options: Enabled, Disabled. Super IO Chip Setup Scroll to Super IO Chip Setup and press <Enter>. The following screen appears: Onboard FDC Controller Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install add-in FDC or the system has no floppy drive, select Disabled in this field. Onboard Serial Port 1/2 Select an address and corresponding interrupt for the first and second serial ports. Options: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto. UART Mode Select This field is to configure which IR mode the 2nd serial port should use. Onboard Parallel Port This field allows the user to configure the LPT port. Options: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled. Page 4-15 BIOS Parallel Port Mode This field allows the user to select the parallel port mode. Options: SPP, EPP, ECP, ECP+EPP, Normal. EPP Mode Select This item allows you to determine the IR transfer mode of onboard I/O chip. ECP Mode USE DMA This field allows the user to select DMA1 or DMA3 for the ECP mode. Game Port Address Select an address for the Game port. Midi Port Address Select an address for the Midi port. Midi Port IRQ Select an interrupt for the Midi port. Options: 5, 10. Page 4-16 BIOS 4-5 Power Management Setup Choose the POWER MANAGEMENT SETUP in the CMOS SETUP UTILITY to display the following screen. This menu allows the user to modify the power management parameters and IRQ signals. In general, these parameters should not be changed unless its absolutely necessary. Figure 6: Power Management ACPI Suspend Type This item allows you to select S1(POS) or S3(STR) function. [. . . ] Open file formats including MP3, CDA, MDI, WAV & WMA support. C. Playback Controls The playback controls include Play, Pause, Stop, Previous, Backward, Forward, & Next. Seeking bar Display Animated Playback Status E. Title/Play List Windows Display Currently Selected Title(s) F. [. . . ]