User manual VICTRON ENERGY 24-1600 230V

[. . . ] all servicing must be undertaken by qualified personnel. Never use the product where there is a risk of gas or dust explosions. Consult the battery manufacturer's information to ascertain that the product is intended for use in conjunction with the battery. Always comply with the battery manufacturer's safety instructions. [. . . ] the vertical position offers optimum cooling. The interior of the product must remain accessible after installation. Try and keep the distance between the product and the battery to a minimum in order to minimize cable voltage losses. For safety purposes, this product should be installed in a heat-resistant environment if it is used with equipment where a substantial amount of power is to be converted. In order to fully utilize the full capacity of the product, batteries with sufficient capacity and battery cables with sufficient cross section should be used. Remark: Internal resistance is the important factor when working with low capacity batteries. Please consult your supplier or the relevant sections of our book "electricity on board", downloadable from our website. Procedure Proceed as follows to connect the battery cables: Use an insulated box spanner in order to avoid shorting the battery. (Safety fuse inside the MultiPlus Compact can be damaged) Secure the nuts tightly in order to reduce the contact resistance as much as possible. This is a Safety Class I product (supplied with a protective grounding terminal). the neutral wire of the AC output of this inverter is connected to the chassis. This is to ensure proper functioning of a GFCI (or RCCB) to be installed in the AC output of the Inverter. The chassis of the product must be connected toground, to the frame (of a vehicle) or the ground plate or hull (of a boat). Procedure The AC output cable can be connected directly to the male-connector at the bottom of the enclosure. From left to right: "N" (neutral), earth, and "L1" (phase). Use a three-wire cable with a flexible core and a cross section of 1. A number of optional connections are possible: 4. 1 Remote on/off switch & remote Control panel The product can be remotely controlled in two ways. Only one remote control can be connected, i. Programmable relay The inverters are equipped with a multi-functional relay that by default is programmed as an alarm relay. 3 Parallel Connection The inverters can be connected in parallel with several identical devices. To this end, a connection is established between the devices by means of standard RJ45 UTP cables. [. . . ] Some settings can be changed with DIP switches Procedure: a) Turn the Compact on, preferably without load. C) Store the settings by moving Dip switch 8 to "on" and back to "off". When connecting a Control panel: should be "on". When connecting a Control panel: should be "off". [. . . ]