User manual VIETA IP2BL DATASHEET

[. . . ] To ensure proper use of this product, please read this owner manual carefully and retain for future reference. Should the unit requires maintenance, contact an authorized service location see service procedure. Use of controls or the performance of procedures other than those specified may result in hazardous radiation exposure. To prevent direct exposure to laser beam, do not try to open the enclosure. [. . . ] A wide picture is displayed on the whole TV screen with a portion automatically cut off. 4:3 LB If you have a conventional TV set and your DVD is formatted for wide screen viewing, use this setting. Wide bands will be displayed on the upper and whole portions of the TV screen. 16:9 If you have a widescreen TV set, use this setting (you must also set your widescreen TV to "full size"). Setting the sound 16:9 (Wide screen) 4:3 LB (Letter Box) * Digital Output Digital output selection enables you to specify the type of digital output suitable for your amplifier or receiver. Select ALL, if you have connected the digital output (COAXIAL or OPTICAL) to a multichannel decoder receiver. Select PCM 96K if the external component is capable of processing digital signal input with sampling rates of 96 kHz. Select PCM 48K if the external component is incapable of processing 96kHz digital signal input, then convert to standard signal with sampling rates of 48 kHz. Select OFF to deactivate the digital output (COAXIAL or OPTICAL). * Night Mode Set night mode to on to lever out the volume. For example, the disc will be play at the same sound level throughout the movie. Center Delay If the listening position is close to the center speaker than the front speakers, you can set the center delay time to improve the surround sound effect. Press key again at the end portion that you want. The specific section will now repeat continuously. Press key the third time to cancel this function. - Note: The A-B can be set only within the same chapter/track. Playback Control (PBC) PBC playback allows you to play Video Cds interactively, following the menu on the display. Stereo All sound is reproduced and played through the left and right speakers. This enable standard stereo reproduction. VSS (Virtual Surround Sound) The ProLogic MPEG or Dolby Digital surround channel is processed by a "virtualiser" DSP to add surround effect from just the two front speakers. Dolby ProLogic Surround The Dolby ProLogic Surround system is a specially encoded two channel analogue format that will produce sound through four speaker channels (front left, center, front right, mono surround) when a Dolby ProLogic Decoder is used. It is also compatible with stereo systems but the user will stereo system but the user will only have two channels (front left and right of sound). Dimming the display screen 1 Select from the menu bar and press key to select different levels of brightness for the display screen: HIGH, MID or LOW. Sleep timer setting Select in the menu bar and press ON or PBC OFF. key to select PBC The sleep timer enables the system to switch to standby mode automatically at a present time. 1 2 Select from the menu bar and press key repeatedly to select a present time. The selections are as follows (time in minutes). To cancel the sleep timer Press key repeatedly until the "OFF" appears. When playing a disc with PBC function Select in the menu bar and press key to select PBC ON or PBC OFF. [. . . ] The Language for the subtitle cannot be changed when you play a DVD l Multilingual subtitles are not recorded on DVD. Changing the language for the subtitles is prohibited on the DVD. The subtitles cannot be turned off when you play a DVD l Depending on the DVD, you may not be able to turn the subtitles off. The angles cannot be changed when you play a DVD l multi-angle are not recorded on the DVD. [. . . ]