User manual VIETA IP2P DATASHEET

[. . . ] . 12 Connecting to an AV Receiver with Digital Audio Input . . 13 Basic Playback Basic Operation . . 14 Advanced Features Modes and Features Setup . . 35 3 Introduction Safety Precautions WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE. [. . . ] Set the player's audio out to Raw or PCM mode. Set the Amplifier to the AV input connected to the DVD player. 13 Basic Playback Basic Operation Preparation before playing: 1. Connect the DVD player to your TV and amplifier. Turn down the volume on your amplifier, and then power it on. Set the TV to the AV input connected to the DVD player. Set the amplifier to the AV input connected to the DVD player. STEP 1 - Press POWER to start the player. STEP 2 - Press OPEN/CLOSE either on the front panel or remote control. When the tray is opened, place the disc on the tray with the label side up. Press OPEN/ CLOSE again to close the disc tray. STEP 3 - Press the PLAY button on the front panel or remote control. [4:3LB] - Letter Box refers to pictures where black bands appear at the top and bottom. [16:9] - The picture fills the screen of a wide-screen (16:9) television. The lock icon will close to indicate that the rating and password are set. Press SETUP to save and exit. 20 Advanced Features Modes and Features Setup Setting DivX-MPEG4 registration Not all DVDs are rated. DVDs that are rated higher than the level you select will not play without SELECTING the correct password. If you forget your Rating password, select 8888 to clear the memory. Keep this password out of reach of children as if will always unlock the Parental Control setting. 21 Advanced Features Remote Control Operation STANDBY During playback, press STANDBY to stop the player and return to standby mode. While the player is in standby, press STANDBY or any key on the front panel to resume normal operation. OPEN/CLOSE To open the disc tray, press OPEN/CLOSE. To close the disc tray, press OPEN/CLOSE again. 0-10+ keys These keys are used to input the time, as well as title, chapter and track numbers. When a numeric item is displayed on the screen, press the 0-10+ keys to select the desired entry, and press ENTER to confirm. A-B During playback, press A-B to select point A. The player will repeat the section from A to B automatically. Press A-B third time to cancel A-B repeat and clear points A and B. Notes: 1. During CD playback, points A and B must be within the same track. [. . . ] Ensure the disc is not scratched or stained. Ensure the AV connector or the output terminal is not damaged. "BAD DISC" DISPLAYED Ensure the disc is not warped, damaged or deformed. Ensure the disc is not badly stained or damaged. [. . . ]