User manual VIEWCAST NIAGARA 4100

[. . . ] Document Number: 40-03288-01-A Date: December 2010 © 2010 ViewCast Corporation. ViewCast, GoStream, ViewCast logo, SimulStream, Niagara, SchedulStream, Niagara logo, Osprey, and Niagara SCX are trademarks or registered trademarks of ViewCast Corporation or its subsidiaries. Microsoft, Windows XP, Windows, and Windows Media are trademarks or registered trademarks of Microsoft Corporation. QuickTime, iPhone, and iPod, are trademarks or registered trademarks of Apple Inc. [. . . ] If you inadvertantly fill all available space, you risk losing your stream during a streaming event. Note: The RTMP Address that displays at the bottom of the window is the Host Address, FMS Address. The File System that displays at the bottom of the window is a combination of the Folder and Filename. Figure 68. Transport Settings 56 ViewCast Niagara 4100 User Guide Adobe Flash Dynamic Streaming Security tab Figure 69. Adobe Flash Dynamic Streaming Security tab To configure security settings: 1. 2. Select the Authentication Type for transport type: Akamai Entry Point LimeLight Server Enter the Username. Note: You can enter a maximum of 80 characters. 3. Enter the Password. Note: You can enter a maximum of 20 characters. ViewCast 57 Advanced Operations Editing an Adobe Flash H. 264 encoder When you create a new encoder, the Encoder Properties window appears. The Encoder Properties windows for editing a new encoder or an existing encoder are identical. You must configure the audio and video settings for each encoder type. Use the Video, Audio, Output, and H. 264 Presets tabs to edit the settings. Configure the video and audio settings, then the streaming properties. The streaming properties and advanced streaming settings are different for each type of encoder. From the Flash Encoder Properties window (Figure 70), you can set the encoder to start streaming automatically by clicking the Auto Start checkbox. You can also start the encoder from this window by clicking the Start Flash Encoder link in the top right corner of the window. Click Encoders All Encoders from the home page. Then select the Edit link next to the encoder whose properties you wish to modify. The system displays the Encoder Properties window for the selected encoder. If you make any changes to the Encoder Properties window, you must click Submit. Otherwise, all your changes will be lost. Figure 70. Flash Encoder Properties 58 ViewCast Niagara 4100 User Guide Video tab Flash adds some additional frame and bit rate controls. The frame rate changes the frames per second that the video will be encoded. The bit rate settings pertain to the amount of data per second the audio and video are captured. Figure 71. [. . . ] The user niagara4100 appears in the list of Administrators. Figure 144. Repeast steps 19 through 22 to add SCXUser as an administrator. ViewCast 133 Appendix C: Mapped Network Drive Setup To create the shared folder: Note: The shared folder(s) must be created on the remote PC. 1. Open the drive where the shared folder will be created. Right click, select New, then Folder. Figure 145. [. . . ]