User manual VIEWSONIC PJL6243

[. . . ] PJL6243 LCD Projector User Guide IMPORTANT: Please read this User Guide to obtain important information on installing and using your product in a safe manner, as well as registering your product for future service. Warranty information contained in this User Guide will describe your limited coverage from ViewSonic Corporation, which is also found on our web site at http://www. viewsonic. com in English, or in specific languages using the Regional selection box in the upper right corner of our website. "Antes de operar su equipo lea cu idadosamente las instrucciones en este manual" Compliance Information FCC Statement This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used. IFA LAMP EXPLODES, THE FOLLOWINGSAFETY PRECAUTIONS SHOULD BE TAKEN. If a lamp explodes, disconnect the projector's AC plug from the AC outlet immediately. Contact an authorized service center for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the projector except those who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass. ViewSonic 62 62 PJL6243 Appendix Troubleshooting Before calling your dealer or service center for assistance, check the items below once again. ­ Make sure you have properly connected the projector to peripheral equipment as described on pages 14-16. ­ Make sure all equipment is connected to AC outlet and the power is turned on. ­ When the projector does not project an image from the connected computer, restart the computer. Problem: No power ­ Solutions ­ Plug the power cord of the projector into the AC outlet. ­ See if the POWER indicator lights red. ­ The projector can be turned on after the POWER indicator turns red. If the WARNING indicator lights red, projector cannot be turned on. ­ Unlock the Key lock function for the projector. See page 53. Theinitialdisplayisnotshown. ­ Make sure Off is not chosen at display function. Theinitialdisplayisnotsame­ Make sure User or Off are not chosen at Logo (select) as the default set . ­ Make sure Input search function is adjusted properly. (ordoesnotswitchautomatically) See page 45. When the projector is on and you press the input source buttons, aniconotherthan the Lamp mode icon appears. An icon other than Input mode or Lamp mode icon appears . [. . . ] 0 Column width can be changed by dragging the right edge of the column. The column order can be changed with drag and drop the column. If it exceeds 1000 events, the oldest event is deleted and the latest event is added. 27 Chapter 3 Basic Operation Storing the management file When you monitor the network equipment with the PJ Network Manager, you can save the registered target information, system setting and event log information into the management file with a free file name. It is useful if you manage multiple equipment in the network. [. . . ]