User manual VINCENT STU-8

[. . . ] Dear Customer, we thank you for the confidence you prove in purchasing our product. It will match your high demands towards sound and manufacturing quality. Though it is understandable that you want to plug and play this product instantaneously, we encourage you to read this manual carefully before installation. It will help you in handling and operating this machine in your system and obtaining the best possible performance, even if it was installed by your dealer. [. . . ] PRESET key Switch between saved stations. TUNING key Manual Frequency search Connect the power cable between device and power supply only after all other connections have been made. DURING INSTALLATION PLEASE OBSERVE THE FOLLOWING ADVICE: Protective caps Prior to the first installation the protective plastic caps must be removed from all the connections used at the rear of the unit. Make sure that you do not get these connections confused during installation!Make sure that you do not mix up the analogue connectors for right and left. The RCA plugs for these are mostly colour coded as follows: red for the right channel, black or white for the left channel. Cable connections Make sure that all plugs fit tightly. Inadequate connections can cause noise interference, failures and malfunctions. This Vincent device uses the European system in accordance with Standard AES14-1992 of the Audio Engineering Society. the structure of the cable is in any event the same. Provided both connected devices meet the same standard, the signal connection is correct. This is always the case if both were manufactured by Vincent. If two devices with different standards are connected, the signal will then be inverted. In this case the signal use on one side of the connection must be changed. Your specialist dealer will assist you with this. - wrong - correct To make the most of the components' sound potential, only high quality loudspeakers and connecting cables, for example Vincent cables, should be used. Your local stockist will be glad to advise you about this. If a wall socket for the FM antenna connection of satellite channels, cable channels or roof antenna is available then connect the radio connection to the input jack "FM 75 (11) on the device. If such a junction is not present, the supplied wire antenna or a commercially available indoor antenna can be connected. Please keep in mind that all devices which respond to the power control are not disconnected from the mains network when switched off. For each connection between two devices one of those cables is needed. The STU-8 has two output connections for the power control. [. . . ] Check the audio connections or switch with the ENTER key (7 / 21) to mono mode. The cable connections are loose, dirty connections, a cable is defective or poor reception. no batteries in the handset , batteries not properly installed or used. The line of sight between the remote and the unit is obstructed, the range was exceeded, or the handset is pressed too far lateral position. [. . . ]