User manual VIPER 700ESP INSTALL

[. . . ] ® 700 ESP Installation Guide ® Version 1. 3 or newer of the Bitwriter® chip is required to program this unit. © 2000 Directed Electronics, Inc. A 1. 1 table of contents What Is Included . 4 Primary Harness (H1), 16-pin Connector . 5 Secondary Harness (H2), 10-Pin Connector . [. . . ] Once the resistor value(s) is determined, refer to the wiring diagram for proper wiring. 22 © 2000 Directed Electronics, Inc. Vista, CA type H: negative (-) multiplex The system is most commonly found in Ford, Mazda, Chrysler and GM vehicles. The door lock switch or door key cylinder may contain either one or two resistors. SINGLE-RESISTOR TYPE: If one resistor is used in the door lock switch/key cylinder, the wire will pulse ground in one direction and resistance to ground when operated in the opposite direction. TWO-RESISTOR TYPE: If two resistors are used in the factory door lock switch/key cylinder, the door lock switch/key cylinder will read resistance to ground in both directions. DETERMINING THE PROPER RESISTOR VALUES: To determine the resistor values, the door lock switch/key cylinder must be isolated from the factory door lock system. For testing, use a calibrated digital multimeter that is set to ohms. To ensure an accurate resistance reading, do not touch the resistor or leads during testing. Cut the output wire from the door lock switch/key cylinder in half. Test with the meter from the switch side of the cut door lock switch/key cylinder wire to a reliable ground source. Some good ground references are the ground input source to the door lock switch/key cylinder or the battery ground. Operate the door lock switch/key cylinder in both directions to determine the resistor values. If the multimeter displays zero resistance in one direction, no resistor is needed for that direction. Once the resistor value(s) is determined, refer to the wiring diagram for proper wiring. © 2000 Directed Electronics, Inc. Vista, CA 23 plug-in harnesses super-bright LED, 2-pin white plug The super bright LED operates at 2V DC. Make sure the LED wires are not shorted to ground as the LED will be damaged. Multiple LED’s can be used, but they must be wired in series. The LED fits into a 9/32-inch mounting hole. Be sure to check for clearance prior to drilling the mounting hole. programmer interface, 3-pin black plug The black three pin port is provided for personal computer programming of the unit. When using the DEI Bitwriter (P/N 998T) or optional PC Interface module (P/N 996T) it is possible to configure any and all of the programmable functions. For more information please refer to the guide packaged with the programmer. on-board doubleguard shock sensor There is a Doubleguard® shock sensor inside the control unit. Adjustments are made via the rotary control as indicated above. [. . . ] When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been bypassed. (See Table of Zones section of this guide. ) © 2000 Directed Electronics, Inc. Vista, CA 35 rapid resume logic Rapid Resume Logic ensures that when the security system is powered back up after power has been disconnected, the system will resume the same state it was in before power was lost. [. . . ]