User manual VISIONEER VRS4 INSTALLATION GUIDE

[. . . ] VirtualReScan 4. 0 Installation Guide 10300468-000 Revision A Copyright Copyright © 2005 Kofax Image Products, Inc. The information contained in this document is the property of Kofax Image Products, Inc. Neither receipt nor possession hereof confers or transfers any right to reproduce or disclose any part of the contents hereof, without the prior written consent of Kofax Image Products, Inc. No patent liability is assumed, however, with respect to the use of the information contained herein. Trademarks Kofax, the Kofax logo, VirtualReScan, the "VRS VirtualReScan" logo, ImageControls, and Adrenaline are registered trademarks of Kofax Image Products, Inc. ; and VRS is a trademark of Kofax Image Products, Inc. [. . . ] From the Actions list, select Take no action. Repeat steps 3-4 until all unnecessary device events are disabled. Note Clear the Take no action selection to restore a device event. 6 7 Click Apply, and then select OK to close the scanner properties dialog box. Close the Control Panel. VRS Installation Guide 39 Verify the Scanner Connection Use this procedure to verify that your scanner is properly connected. To check the scanner connection status 1 2 3 4 From the Windows desktop, right-click on My Computer. From the left pane of the Computer Management console, double-click the Device Manager icon. The devices on your system will appear in the right pane. Expand the Imaging devices node. Figure 2-15. Computer Management - Imaging Devices 40 VRS Installation Guide 5 If your scanner appears under Imaging devices, as in Figure 2-15, it has been properly connected to your system. If your scanner is not listed as an imaging device, check the USB/FireWire cable connection or try restarting the computer. Then check again to see if the device is listed. If your scanner still is not connected, you may need to seek technical support assistance from your scanner manufacturer. Close the Computer Management console. 6 VRS Installation Guide 41 Resolve the Found New Hardware Wizard Event Use the procedure in this section to resolve the Found New Hardware Wizard event that may occur after you have attached the scanner to your computer. 1 When the Found New Hardware Wizard appears, as in Figure 2-16, select to install the software automatically and then click Next. Figure 2-16. Windows Found New Hardware Wizard 2 If the wizard is unable to detect the appropriate drivers and files, another screen will appear. In this case, select the option labeled "Don't Prompt Me Again to Install This Software" and click Finish. Select the option to restart your computer. VRS Installation Guide 3 42 Alternatively, Windows 2000 users may use the following procedure: 1 At the screen similar to Figure 2-16, insert the VRS installation CD in the appropriate drive, select to install the software automatically and then click Next to search for a driver. Select the option to search CD-ROM drives. Select the option to disable the device, click Finish to end, and then select the option to restart your computer. 2 3 VRS Installation Guide 43 Install the Scanning Application Use the procedure in this section to install the scanning application that you plan to use with VRS. Note If desired, you can perform low-volume scanning with Kofax VCDemo or Scan Demo, the ImageControls-based demonstration scanning applications that are included with every VRS installation. For more information about VCDemo, refer to Appendix C, Using VCDemo on page 91. [. . . ] This option opens a dialog box from which you can apply settings such as rotation and image scaling. Use these options to scale the displayed image. Use this option to toggle the "correct aspect ratio" feature. This feature is useful for enhancing the display of images with different horizontal and vertical DPIs (such as fax images). [. . . ]