User manual VISONIC DUO AM K9 85

[. . . ] The ventilation slots must not be blocked and the unit must be kept free of dust. A proper airflow must be maintained through the unit to obtain an air sampling of that area of the house where the sensor is situated. The unit must be installed at least three feet from any gas appliance to eliminate false alarms but should not be placed over 20 feet from such appliances. Install the unit away from any sources of vapor such as alcohol, liquor, vehicle exhaust, hair spray, cleaning agents, deodorants, paint, fluorocarbons, or industrial solvents because vapors from these substances will trigger false alarms. [. . . ] Seek a qualified technician or call your local gas company Compatibility: Compatible with all PowerMax alarm system family (PowerMax / PowerMax+ / PowerMax Pro / PowerMaxComplete), MCR-304 receiver, MCR-308 receiver or any other PowerCode alarm system. 2125 or other frequency according to local requirements. Audible Signal Volume: At least 85 dB at a distance of 3 m. Important: The detector will not operate without 220V power connection. In the event of a power failure or where the detector is not connected to a power source, an AC failure message is sent to the control panel (will be received by PowerMax+ version 3. Therefore, when installing the DUO AM K9 85, to work with PowerMax or PowerMax+ revision 2. 9 and down, it is highly recommended not to disable the PowerMax/PowerMax+ "supervision" function (See "Define Control Panel Parameters" in the PowerMax Programming Guide or PowerMax+/PowerMax Pro/PowerMaxComplete Installer Guide). For proper installation, see figure 3 & 4. Refer to the target receiver's installation instructions and follow the procedure given there for "teaching" IDs. When you are instructed to initiate a transmission from the DUO AM K9 85, press the Test / Silent button (see Figure 1). 9 and down, you have to cause the detector not to send AC failure messages, as follows: Continuously press the Test/Silent button for 10 seconds approximately, until a long beep (2 seconds) is heard. Any repair and/or replacement shall not extend the original Warranty period. The Manufacturer shall not be responsible for dismantling and/or reinstallation costs. To exercise this Warranty the Product must be returned to the Manufacturer freight pre-paid and insured. All freight and insurance costs are the responsibility of the Purchaser and are not included in this Warranty. This warranty shall not be modified, varied or extended, and the Manufacturer does not authorize any person to act on its behalf in the modification, variation or extension of this warranty. This warranty shall apply to the Product only. All products, accessories or attachments of others used in conjunction with the Product, including batteries, shall be covered solely by their own warranty, if any. The Manufacturer shall not be liable for any damage or loss whatsoever, whether directly, indirectly, incidentally, consequentially or otherwise, caused by the malfunction of the Product due to products, accessories, or attachments of others, including batteries, used in conjunction with the Products. This Warranty is exclusive to the original Purchaser and is not assignable. This Warranty is in addition to and does not affect your legal rights. Any provision in this warranty which is contrary to the Law in the state or country were the Product is supplied shall not apply. [. . . ] This action should be performed once a week. Use the Test / Silent button (see Figure 2) to switch off the acoustic alarm tone in the event of an alarm. The red LED will continue to flash and a short signal tone will sound approximately every 45 seconds. Visonic Limited (the "Manufacturer") warrants this product only (the "Product") to the original purchaser only (the "Purchaser") against defective workmanship and materials under normal use of the Product for a period of twelve (12) months from the date of shipment by the Manufacturer. [. . . ]