User manual VISONIC MC-302 PG2

[. . . ] Magnet Figure 1: External View B 2. SPECIFICATIONS Frequency Band (MHz): Europe: 433, 868, USA: 915 Modulation: GFSK Antenna: Built-in helical antenna. Tamper Alert: Reported when a tamper event occurs. Battery type: 3 V Lithium CR-123 type battery, Panasonic or Sanyo only. [. . . ] MODIFY DEVICE SETTINGS This section describes how to configure the parameters of contact sensors from the PowerMaster-10 control panel. To Modify the Contact Sensor Settings Refer to the PowerMaster-10 Installer Guide and perform the procedure for Adding A Wireless Device (section 4. 5. 2), or, Modifying a Device (section 4. 5. 5). Then continue below to modify the device settings. Alarm LED When exiting "ZONES / DEVICES" menu, the PowerMaster-10 system displays the number of devices that need to be updated, as follows: DEV UPDATING NNN. For detailed instructions on Adding Devices, Deleting Devices, Replacing Devices and Defining Defaults see the PowerMaster-10 Installer Guide. or Select between "LED ON" and "LED OFF". Here you determine whether or not the alarm LED indication will be activated. 6. LOCAL DIAGNOSTICS TEST Before testing, separate the base from the cover (see Fig. Press the tamper switch once and release it. Put back the cover to return the tamper switch to its normal (undisturbed) position, and then secure the front cover to the base with the case closure screw. Momentarily open the door or window and verify the red LED blinks, indicating detection. The following table indicates received signal strength indication. LED response Green LED blinks Orange LED blinks Red LED blinks No blinks Reception Strong Good Poor No communication IMPORTANT!Therefore, "poor" signal strength is not acceptable. If you receive a "poor" signal from the device, re-locate it and re-test until a "good" or "strong" signal strength is received. Note: For detailed Diagnostics Test instructions refer to PowerMaster-10 Installer Guide. 2 D-302412 7. wireless systems are very reliable and are tested to high standards. However, due to low transmitting power and limited range (required by FCC and other regulatory authorities), there are some limitations to be considered: A. Receivers may be blocked by radio signals occurring on or near their operating frequencies, regardless of the digital code used. A receiver responds only to one transmitted signal at a time. Wireless devices should be tested regularly to determine whether there are sources of interference and to protect against faults. The user is cautioned that changes or modifications to the unit, not expressly approved by Visonic Ltd. , could void the user's FCC or other authority to operate the equipment. D-302412 3 WARRANTY Visonic Limited (the "Manufacturer") warrants this product only (the "Product") to the original purchaser only (the "Purchaser") against defective workmanship and materials under normal use of the Product for a period of twelve (12) months from the date of shipment by the Manufacturer. [. . . ] Any provision in this warranty which is contrary to the Law in the state or country were the Product is supplied shall not apply. Warning: The user must follow the Manufacturer's installation and operational instructions including testing the Product and its whole system at least once a week and to take all necessary precautions for his/her safety and the protection of his/her property. Product Recycling Declaration For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not returning it for repair then you must ensure that it is returned as identified by your supplier. [. . . ]