User manual VISONIC MCT 320

[. . . ] After three consecutive "low battery" states, a supervisory `low battery' alarm code is transmitted. The transmitter case is waterproof, hermetically sealed (no screws) and therefore disposable. Do not attempt to open the transmitter case or replace the battery; such action will void the warranty. User's Guide Figure 1 - Using the MCT 320 * An alarm system with PowerCodeTM receiver or interface (like POWERMAX, MCR-308, EXP-1600W, etc. ), in which the RFR-4 receiver module is installed. Figure 2 - MCT 320 with Neck Cord The transmitter is supplied with two wearing accessories, a neck cord (to be worn around the neck - see figure 2) and a clip (to be attached to the user belt or shirt pocket - see figure 3). The neck cord includes a built-in safety release mechanism. This neck cord must never be replaced with a cord that does not include a safety release. Figure 3 - Clip Attachment 2. [. . . ] Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the manufacturer's instructions. Battery self-test and reporting - every 12 hours and if 3 consecutive "low battery" states are detected, a "low battery" alarm is transmitted. Operating Temperature: 0°¡ to 50°C (32°F to 122°¡F) Dimensions (H x W x D): With Clip: 73 x 41 x 30 mm (2-7/8 x 1-5/8 x 1-3/16 in. ) Without Clip: 67 x 41 x 21 mm (2-5/8 x 1-5/8 x 13/16 in. ) Weight: 35 g (with clip), 30 g (without clip) Color: Gray Compliance with Standards: ETS 300 683, EN300220, EN 50131-1 Grade 2 Class II. This device complies with the essential requirements and provisions of Directive 1999/5/EC of the European Parliament and of the Council of 9 March 1999 on radio and telecommunications terminal equipment. The technical documentation as required by the European Conformity Assessment procedure is kept at: UNIT 6 MADINGLEY COURT CHIPPENHAM DRIVE KINGSTON MILTON KEYNES MK10 0BZ. Telephone number: 0870 7300800, Fax number: 0870 7300801 C. Battery Condition Indication and Reporting: A. Good battery - the LED lights steadily upon transmission. Low battery - when transmission button is pressed, "low battery" alarm code is transmitted and the LED flashes. DE2276U 1 3. MISCELLANEOUS COMMENTS 3. 1 Product Limitations Our wireless systems are very reliable and are tested to high standards. However, due to their low transmitting power (required by FCC, DTI and other regulating authorities) there are some limitations to be considered: A. Receivers may be blocked by radio signals occurring on or near their operating frequencies, regardless of the code selected. The Manufacturer shall not be responsible for dismantling and/or reinstallation costs. To exercise this Warranty the Product must be returned to the Manufacturer freight pre-paid and insured. All freight and insurance costs are the responsibility of the Purchaser and are not included in this Warranty. This warranty shall not be modified, varied or extended, and the Manufacturer does not authorize any person to act on its behalf in the modification, variation or extension of this warranty. This warranty shall apply to the Product only. All products, accessories or attachments of others used in conjunction with the Product, including batteries, shall be covered solely by their own warranty, if any. The Manufacturer shall not be liable for any damage or loss whatsoever, whether directly, indirectly, incidentally, consequentially or otherwise, caused by the malfunction of the Product due to products, accessories, or attachments of others, including batteries, used in conjunction with the Products. This Warranty is exclusive to the original Purchaser and is not assignable. This Warranty is in addition to and does not affect your legal rights. Any provision in this warranty which is contrary to the Law in the state or country were the Product is supplied shall not apply. Warning: The user must follow the Manufacturer's installation and operational instructions including testing the Product and its whole system at least once a week and to take all necessary precautions for his/her safety and the protection of his/her property. [. . . ] Product Recycling Declaration For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not to be thrown away with everyday waste. Directive 2002/96/EC Waste Electrical and Electronic Equipment. VISONIC LTD. [. . . ]