User manual VISONIC NEXT CAM PG2

[. . . ] NEXT CAM PG2, NEXT CAM-K9 PG2 Wireless, PowerG, PIR / Pet Immune Detectors with Integrated Camera 1. INTRODUCTION The Next CAM PG2 is a 2-way, microprocessor-controlled, wireless digital PIR detector with integrated camera and microphone for alarm verification. Activated upon PIR detection or upon demand, the Next CAM PG2 sends clear images with optional audio to the Monitoring Station. It thus enables accurate status assessment of the premises. [. . . ] Select 160 x 120 for lower quality or 320 x 240 for higher quality. or Select between "Black & White" and "Color". Here you determine whether the image will be in black & white or color. or Select between "NOT connected" and "Connected to AC". Here you determine whether or not to report power failure and restore. D-302893 3 5. Separate the base from the cover (see Fig. Put back the cover to return the tamper switch to its normal (undisturbed) position, and then secure the front cover to the base with the case closure screw. Walk across the far end of coverage pattern in both directions, The red LED lights each time your motion is detected followed by 3 LED blinks. The following table indicates received signal strength indication. LED response Green LED blinks Orange LED blinks Red LED blinks No blinks Reception Strong Good Poor No communication IMPORTANT!Therefore, "poor" signal strength is not acceptable. If you receive a "poor" signal from the detector, relocate it and re-test until a "good" or "strong" signal strength is received. Note: For detailed Diagnostics Test instructions refer to the control panel Installer Guide. A A. INSTALLATION 6. 1 General Guidance (see fig. Mount on solid stable surface. 1 2 3 4 5 6 WARNING!To comply with FCC RF exposure compliance requirements, the PIR detector should be located at a distance of at least 20 cm from all persons during normal operation. The antennas used for this product must not be co-located or operated in conjunction with any other antenna or transmitter 7 Figure 4. The Next CAM-K9 PG2 detector is immune to 38 kg (85 lb) animals moving on the floor or climbing on furniture as long as the activity takes place below 1 m (3 ft). Above the 1 m (3 ft) height limit, the detector is immune to 19 kg (42 lb) pets, but the pet immunity will decrease as the pet gets closer to the detector. It is therefore recommended to select a mounting location that minimizes potential close proximity of animals. 6. 2 Mounting 2 3 1 A 4 D-302893 B 5 4 6 C 7 F D G E *CAUTION! THE BACK TAMPER SWITCH WILL NOT PROTECT THE UNIT UNLESS THE BREAK-AWAY BASE SEGMENT IS SECURED TO THE WALL WITH AT LEAST ONE SCREW. Mounting on Wall 8 9 Figure 5b. Position the battery in the battery holder and insert the battery connector terminal into the battery connector. For optional mains power supply: Break the cable entry knockout and insert the mains cable. [. . . ] Any provision in this warranty which is contrary to the Law in the state or country were the Product is supplied shall not apply. Warning: The user must follow the Manufacturer's installation and operational instructions including testing the Product and its whole system at least once a week and to take all necessary precautions for his/her safety and the protection of his/her property. 1/08 However, there is no guarantee that interference will not occur in a particular installation. If this device does cause such interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the interference by one or more of the following measures: ­ Re-orient or re-locate the receiving antenna. [. . . ]