User manual VISONIC SR-720 PG2 INSTALLATION

[. . . ] Entry delay beeps sound once the user has entered the protected area. (Entry/exit beeps can be enabled / disabled from the control panel Installer menu. ) · Squawk indications: Squawk (beep) sounds can be used to indicate alarm system arming (1 squawk) and disarming (2 squawks) by a keyfob (squawk can be enabled from the control panel User menu). · Double Tamper protection: When the siren front panel is removed or when the siren is removed from the wall, tamper alarm is sent to the alarm system. [. . . ] INSTALLATION 3. 1 Installation A 2 (*) A A 1 3 4 5 B 1. Using Philips screwdriver, remove screw and remove cover. Figure 2: Installation 3. 2 Battery Pack Insertion B A A. Battery cable Figure 3: Battery Pack Insertion 3. 3 Cover Closure See Figure 4. 1. Secure with screw. 1 G C F 2 D E Figure 4 - Cover Closure 4. ENROLLMENT Refer to the control panel Installer Guide for the device enrollment procedure. 2 D-303089 5. SR-720 PG2 DEVICE SETTINGS This section describes how to configure the parameters of the siren from the control panel. To Modify the Siren Device Settings Refer to the control panel Installer Guide and perform the procedure for Adding A Wireless Device (section 4. 5. 2), or, Modifying a Device (section 4. 5. 5). Then continue below to modify the device settings. STROBE ALARM Here you determine whether or not to activate the strobe alarm, and if to activate whether to activate the strobe until the alarm system is disarmed, or, for the programmed period of time (see section "Siren Configuration" in the control panel Installer Guide). 2. AUTO TAMPER ALRM When exiting "INSTALLLER MODE" menu, the alarm system displays the number of devices that need to be updated, as follows: "DEV UPDATING NNN". For detailed instructions on Adding Devices, Deleting Devices, Replacing Devices and Defining Defaults see the control panel Installer Guide. or Select between "Disabled" and "Enabled". Here you determine whether or not the siren alone will sound a tamper alarm when there is no communication between the siren and the control panel. or Select between "Volume HIGH", "Volume LOW" and "Volume MID". Here you determine the volume level of the sounder. or Select between "Disabled", "Sounder only", "Strobe only" and "Sounder+strobe". Here you determine whether or not to activate the squawk, and if enabled, whether to activate the sounder only, or, the sounder and strobe simultaneously. [. . . ] To exercise this Warranty the Product must be returned to the Manufacturer freight pre-paid and insured. All freight and insurance costs are the responsibility of the Purchaser and are not included in this Warranty. This warranty shall not be modified, varied or extended, and the Manufacturer does not authorize any person to act on its behalf in the modification, variation or extension of this warranty. [. . . ]