User manual VITEK VTD-C510

[. . . ] VTD-C510 High Resolution Color Indoor Dome Camera VITEK The VTD-C510 high resolution color dome camera is a small, attractive camera ideal for use in commercial or residential applications. It measures less than 5" in diameter and comes in dual voltage 24 Volt AC/12 Volt DC power input for easy integration with standard cameras and power systems. · 1/3" High Resolution CCD (768 x 494) · 580 TV Lines Resolution · DSP Controls For Superior Backlight, White Balance, And Gain Control · 0. 03 Lux Sensitivity · Dual Voltage: 12VDC / 24VAC · Also available in white BLACK WIRING CONNECTIONS The VTD-C510 Dome Camera should be powered by 12 Volts DC or 24 Volts AC. [. . . ] The following adjustments may be made: Dip Switch Adjustments Dip Switch 1 (Default ON) AE: Automatic Electronic Shutter Control Leave this switch in the "On" position when using a fixed lens version to enhance the camera's ability to react to changing light. Switch to "Off" position if your camera has an auto iris lens. Dip Switch 2 (Default OFF) BLC: Back Light Compensation Leave this switch in the "Off" position if your camera is being installed outdoors or if the installation is indoors in a controlled lighting environment. Switch to "On" position when installing the camera indoors looking toward windows or doors or if outdoors looking into semi-direct sunlight. Never install camera looking into direct sunlight. Dip Switch 3 (Default OFF) FL: Flickerless Flickerless shutter speed for minimizing image flicker under fluorescent lighting. AGC: Automatic Gain Control Used to increase the video signal in low light conditions. If used in the wrong environment, this setting can add noise in the picture giving a grainy appearance. Dip Switch 4 (Default OFF) 3 BLACK FOCUS ADJUSTMENT The focus may be adjusted by simply screwing or unscrewing the lens. Be sure to loosen the set screw before attempting to adjust the focus or damage may occur. Be careful not to over tighten the lens or you may damage the pick-up sensor. Focus Adjustment SECONDARY VIDEO OUTPUT The VTD-C510 is equiped with a Secondary Video Output for ease of setup and adjustment. A 6" cable is included with the camera. Secondary Video Output & Cable. 4 ROUTINE MAINTENANCE Use mild liquid cleaners to remove dirt and grime from the dome surface. Do not use harsh or abrasive cleaners which can scratch the polycarbonate dome and reduce visibility for the camera. If the camera view is obstructed by scratches, remove the front plate (bezel) and rotate the bubble to a portion that is not scratched. If the dome becomes damaged or scratched beyond use, contact your distributor to order a replacement. 5 BLACK NOTES 6 DOME SPECIFICATIONS Image Device Effective Pixels Resolution Minimum Illumination S/N Ratio Electronic Shutter White Balance Standard Lens Video Output Power Source Operation Temp: Dimensions Weight 1/3" Color CCD Image Sensor 768 x 494 580 TV Lines 0. 03 Lux at f1. 2 (AGC ON) More Than 48dB (AGC Off) 1/60 ~ 1/100, 000 Sec. [. . . ] This guarantee does not affect your statutory rights. Contact your local VITEK Reseller should servicing become necessary. 28492 CONSTELLATION ROAD VALENCIA, CA 91355 WWW. VITEKCCTV. COM | 888-VITEK-70 8 [. . . ]