User manual VIVANCO 2 IN 1 TVDVB UNIVERSAL REMOTE CONTROL

[. . . ] Check that the polarity markings on the batteries and in the battery compartment are correctly lined up (+=+), then close the flap carefully. ⭠Always use undamaged , fully charged batteries. 2 Adapting to appliances In order to control your appliances you must adapt or set the remote control to them. [. . . ] 2 2nd number of code (tens = Channel+): Press the CH+ (channel up) button four times for the 4 of 241. 3 3rd number of code (ones = Volume+): Press the VOL+ (volume up) button once for the 1 of 241. If incorrect entries are made the remote control blinks for about 3 seconds. 5 The UR Zap 2 II emits a different signal every 1. When your appliance reacts, very quickly press the Mute button to confirm a functioning control code. ­ It is advisable to have your finger already placed on the Mute button so that you can react quickly enough. Otherwise the UR Zap 2 II emits the next signal before you have reacted. 6 Finally, test the control code setting by trying to control your DVB (SAT, CBL) appliance. If it does not work correctly, please try the code search again. DVB (SAT, CBL), back on again if you wish to continue searching. 3 Code Identification You can identify the codes you have set at any time: 1 Select the appliance to be controlled using the TV or DVB (SAT, by trying to control (in this example) your CBL) button. 2 Keep the On/Off PWR and Mute not correctly try a different code from the list or code search (see below). 6 To make the setting for a DVB the lamp lights constantly. First press Vol briefly and count the CBL) code accordingly. [. . . ] The lower channel number settings are frequently the most important channels. Scan: When you press this button a channel-up signal CH+ is emitted every 1, 3 seconds and the following channels are shown one after the other without your having to press a button repeatedly. This function stops when you press any button and ends automatically after 2 minutes. [. . . ]