User manual VIVANCO UNIVERSAL LCD 8 IN 1 REMOTE CONTROL

[. . . ] Adapting to devices In order to control your devices you must adapt or set the remote control to them. There are two ways of doing so: direct control code entry or code search. If the UR 850 LCD does not understand you it displays ERROR and you can then repeat the entry. SEARCH does not appear you can set the function with the or button. [. . . ] When the code corresponds to your device, press OK and the setting for this device is completed. If the code you have found does work at all or not properly, try another code by selecting the next code for the brand using the or button, then test the code as described above under 4. Instead of the TV device button, press another button, e. - You can interrupt code entry at any time by pressing EXIT. 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. 3 Enter the time using the number buttons and confirm with the OK button. Then press EXIT several times to quit the setting mode. Set priority volume control With this function you can determine a device exclusively for volume control, e. Then the buttons VOL +, VOL ­ and always control the amplifier, regardless of which device you are controlling. Code search If the brand of your appliance is not in the list or none of the codes given fits, we recommend the automatic code search. Your remote control finds the correct control settings almost automatically in a few seconds: 1. For example, a program number appears in the display of your satellite receiver. 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. 4 Then press EXIT several times to quit the setting mode. - You can cancel the priority setting using the same procedure. Locking or releasing device codes To prevent settings from being changed accidentally, proceed as follows: 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. TV for the television and set lock=ON using the or button. 4 Then press EXIT several times to quit the setting mode. [. . . ] For technical reasons, the LCD panel becomes almost illegible after a reset. You can make it legible again by greatly reducing the contrast as described in the section Adjusting the contrast. 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. Operation You operate your appliances basically in exactly the same way as if you were using the original remote controls, except that you must first press a device button (TV, DVD, etc. [. . . ]