User manual VIVANCO UR 1200

[. . . ] Please note: - You can reverse the search direction with the or button if you have reacted too slowly to a response from the device. ­ The Menu buttons cannot by used for testing. - You can interrupt code search at any time by pressing EXIT. If the brand of your appliance is not in the list or none of the codes given fits, we recommend the automatic code search. [. . . ] You can capture upto 100 key funtion codes, max 40 per device. Press SET for more than 3 seconds and release it, when CODE SETUP is displayed. Then SELECT KEY is displayed and the next key can be programmed according to step 5 and 6. ­If the programming fails, FAILED is displayed, then repeat reprogramming from step 5. You can stop learning procedure by pressing any device key (TV, DVB etc. Press SET for more than 3 seconds and release it, when CODE SETUP is displayed. Then SELECT KEY is displayed and the next key can be deleted according to step 5 and 6. ­If the deleting fails, WAITING and FAILED are displayed, then repeat deleting from step 5. You can stop deletion procedure by pressing any device key (TV, DVB etc. Press SET for more than 3 seconds and release it, when CODE SETUP is displayed. Then press the corresponding device key key, e. 5 Press OK when sequence input is finished and macro shall be stored. delete Macros Please proceed as follows , see Fig. 12: 1 Press and hold SET for 3 seconds, then set MACRO with the or button. 6 Then press EXIT several times to quit the deletion mode. Control Any Device On AUX You can use the AUX device key to control any device. If you want to control a 2nd VCR by AUX key, please proceed as follows, see Fig. 13: 1 Press and hold SET for 3 seconds, then CODE SETUP is displayed. VCR, OK and enter code number of required to be by AUX controlled device, e. 4 Then press EXIT several times to return to main control menu. Backlight To save battery capacity you can switch off the LCD illumination. To do so, proceed as follows: 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. [. . . ] - This function is recommended only in the event of your remote control malfunctioning seriously. 1 Press and hold SET for 3 seconds, then set CONFIGURE with the or button. Operation You operate your appliances basically in exactly the same way as if you were using the original remote controls, except that you must first press a device button (TV, DVD, etc. As the symbols on the UR 820 LCD could differ from those on the original remote controls you may have to try out all the buttons in order to find the functions. [. . . ]