User manual VIVANCO CSI RF-HEADPHONES SET

[. . . ] Constant use at high volumes impairs your hearing and may cause permanent damage. Do not dispose of this product with the domestic waste; take it to your local electronic waste recycling depot. To completely isolate the device from the mains supply, the plug-in power supply must be pulled out of the mains outlet. Therefore, the device must be placed in such a way that unhindered access to the mains outlet is always ensured, so that the plug-in power supply can be immediately pulled out in an emergency. [. . . ] This toggles between the digital and analogue inputs. Gain Switch If you connect audio sources that have a lower output level (such as an MP3 player) at the analogue port of the transmitter, you can lift the level and hence make it louder. set the Gain switch on the transmitter to "high" and the signal is subsequently amplified. Stand-by Mode The transmitter and the operation indicator light automatically go into standby mode when there is no signal for about 5 minutes or if it is too weak. When the signal is present again, or is strong enough, it automatically goes into ready-to-transmit mode. Pairing The Pairing function connects the transmitter with one or more receivers. In this manner, several cordless headphones of similar type can be paired to one transmitter without losing the eavesdropping protection feature. it is also possible to operate cordless headphones in parallel. To do so, follow the procedure below: Renewed pairing of transmitter and cordless headphones or the operation of several sets (cordless headphones and transmitters) in parallel. A maximum of 2 sets can be operated in parallel: When operating several sets in parallel, please note that while pairing, the sets must be more than 60 cm from one another. Pull the plug-in power supply of the transmitter and switch off the cordless headphones. Use it to carefully press the Pairing button on the transmitter and simultaneously insert the plug-in power supply as well. Press the Pairing button on the transmitter till the operation indicator light on the cordless headphones glows continuously. 7 numbers): Always keep in mind that the transmitter and the cordless headphones can be a maximum of 60 cm from one another. Switch on the transmitter and the cordless headphones and make sure that music can be heard. Now take the second set of cordless headphones and switch it on. The second cordless headphone set is now also paired with the transmitter and you can hear your music. Repeat the steps for every additional cordless headphone set. To open the battery compartment, carefully pull off the ear cushion from the left side earshell "L". Insert the batteries or rechargeable batteries (micro, type AAA) into the battery compartment, observing the correct polarity. [. . . ] The warranty period is 24 months from the date of purchase. European contacts can be found at http://www. If your device should not function properly, please proceed as follows: 1. Using the following table of malfunctions, try to find and correct the fault. [. . . ]