User manual VIVITAR DVR-200

[. . . ] FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] You may select still image resolution of either 1600x1200 and 800x600. Use 1600 x 1200 higher resolution if you prefer a larger print. However, this will also produce a larger file size. You may also specify an image compression setting, selecting from Super Fine, Fine, and Normal. Higher quality images will yield better images, but require more memory space. High resolution and quality settings are recommended for printed output and situations requiring the finest detail. Lower resolution and quality images take up less memory space and may be quite suitable for sharing images via e-mail, in a report, or on a web page. To 1. 8. change image resolution and quality settings: Press the power/menu button to display the menu options. Select Record menu by using the or buttons. Press the button to enter the main menu. Select Image size or Image quality by using the or buttons, and press the button. Change the settings with the or buttons and then press the OK button. Press the power/menu button again to exit from the menu mode. Press the shutter button. 20 Number of recordable images The frame counter indicates the approximate number of images that can be stored in the internal memory (or SD memory card ) at the current image quality and resolution settings. The number of recordable images will vary depending on the recorded subject (scene complexity) and the capacity of the memory card. Resolution Quality Super fine Fine Normal Super fine Fine Normal Compression 64MB ratio internal memory 4:1 8:1 12:1 4:1 8:1 12:1 91 136 182 364 546 728 64MB SD memory card 86 129 173 346 519 692 1600 x 1200 pixels 800 x 600 pixels * The above data shows the standard testing results. The actual capacity varies according to shooting conditions and settings. 21 RECORD MODE Recording video clips The digital video camera records MPEG-4 video at a resolution of 320x240 pixels at a frame rate of 25 fps. Press the power/menu button to turn on your camera. record button. To start recording a video clip by press the The zoom state, the battery level, card indicator, the movie mode and the elapsed time will display on the LCD monitor when recording a video clip. To stop recording, press the record button again. The table below indicates the approximate duration of recording time that you can record at each setting based on 64MB internal memory. Resolution 320 x 240 pixels Video Quality Super fine Fine Normal Estimated Recording Time Approx. 17 min. Note: In record mode, the digital zoom function can be used. In record mode, the self-timer cannot be activated. In record mode, the flash mode is automatically set to [Off]. [. . . ] If this happens, you may reset the date and time. For more information about the date setup, refer to "Setting the date and time". Date imprint If you select the imprint feature, the date will be embedded into your images. To enable this function, first press the button. Then select [On] or [Off] by using the press OK button to confirm. [. . . ]