User manual VIVITAR VIVICAM 2005

[. . . ] Vivicam 2005 User Manual 041227TP 1 Preface Thank you for purchasing the Vivicam 2005. Please read this manual carefully, it covers all camera functions and operations. FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. [. . . ] Data stored in internal memory will not be accessible if a memory card is present. To again access your data stored in internal memory, simply remove the SD memory card. 6 2. Preparation For Use 2. 1 Loading batteries 1. Open the battery cover as shown in Figure 3. 2. As indicated inside the battery cover ("+/-"), load three AAA batteries into the compartment with the polarity (orientation) as shown in Figure 4. Note: Typically, the V2005 will come with alkaline batteries. Whereas alkaline batteries will operate the camera, Nickel-Metal Hydride (Ni-MH) rechargeable batteries are highly recommended because they offer superior performance. Rechargeable NiMH batteries are both cost effective and reusable. To maximize performance and lifetime, it is recommended that you fully charge the batteries and discharge them for at least one complete cycle before use. Battery Compartment Memory card Slot Figure 3 ­ Battery Cover Door 3. Close the battery cover. Figure 4 ­ Battery Orientation 2. 2 Inserting a Memory Card 1) Open the battery cover 2) Insert an SD memory card into the slot in the indicated direction Insert contact pins first Label-side of memory card facing towards the back (TFT side) of camera Press the card gently into the slot ­ it will "click" into place To remove a memory card press gently on the edge of the card to eject it 3) Close the battery cover 7 3. Camera Operations 3. 1 Capturing Images and Video Clips The Vivicam 2005 features three ways to capture images 1) Single Shot mode. Single-shot mode is the most common mode used for capturing individual still images. Single shot is also the default mode for the V2005. Whenever the camera is turned on, it will be in single-shot mode. Note that after each video captured, the camera will revert to single-shot mode. Burst mode allows you to capture a sequence of four images in succession. The V2005 will capture one frame (every 1. 2 seconds) up to four frames. The indicator is a three-segment gauge: : Full battery capacity : Low battery capacity : Virtually out of power, camera will power off automatically soon When the camera is out of power, it will power off automatically. 4. 3 Capturing Images and Video clips Press the Menu button to select capture mode: Capture mode. Use left and right buttons (" " and " ") to select OFF Figure 5 ­ Capture mode icon " (Figure 5). Press OK to open the submenu as shown in Figure 6. capture mode " : Single image capture Video clip mode OFF Figure 6 ­ : Burst mode (4 images) Note: the default mode is single image capture Capture modes Image resolution. "SF", "F"and "E"indicate image resolution (quality. ) You may select image resolution from the setup menu. SF (Super-Fine), 1600 x 1200 (2 megapixel) F (Fine), 1280 x 960 E (Economy), 640 x 480 Note: The default setting is Super-Fine 9 Flash Mode. [. . . ] Double click on the DCIM folder to open it to find more folders - your images and video clips will be inside these folders (Often times a new window will Mac users: double-click the "unlabeled" disk drive icon on our desktop. Step 2: Transfer images to your computer. iPhoto may automatically launch. The volume label may vary depending upon whether you use internal When the camera is turned on and connected to your computer, it is considered to be a disk drive, just like a floppy disk or CD. You can download (transfer) images by copying them from the "removable disk" ("untitled" disk on a Macintosh) to your computers hard drive. 13 Windows Open the "removable disk" and subsequent folders by double clicking on them. [. . . ]