Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual VOLTA 2855. We hope that this VOLTA 2855 user guide will be useful to you.
Lastmanuals help download the user guide VOLTA 2855.
Detailed instructions for use are in the User's Guide.
[. . . ] Please have the nearest Authorized SharpVision Service Center or Dealer (for 2855U) or Sharp Authorized Projector Dealer or Service Center (for 2855E) replace the lamp if rupture occurs. [. . . ] Wait at least one hour after the power cord is disconnected to allow the surface of the lamp cage to fully cool before removing the lamp cage. It is recommended that the lamp be replaced after approximately 1, 900 cumulative hours of use or when you notice a significant deterioration of the picture and color quality. Carefully change the lamp by following the steps below. If the new lamp does not light after replacement, take your projector to the nearest Authorized SharpVision Service Center or Dealer (for 2855U) or Sharp Authorized Projector Dealer or Service Center (for 2855E) for repair.
IMPORTANT NOTE TO U. S. · Replace the lamp after turning off the power and unplugging the power cord.
1
Turn off the power.
2
Unplug the power cord.
3
Remove the lamp cage cover.
4
Remove the lamp cage.
Press POWER OFF. Wait until the cooling fan stops running.
Loosen the user service screw that secures the lamp cage cover on the side of the projector. Then lower the cover in the direction of the arrow (to the open mark).
Remove the three-securing screws from the lamp cage. Hold the lamp cage by the handle and pull it horizontally towards you.
User service screws
5
Insert the new lamp cage.
6
Attach the lamp cage cover.
7
Plug in the power cord.
8
Press POWER ON on projector to reset lamp timer.
"LAMP 0000H" is displayed, indicating that the lamp timer is reset.
Press the lamp cage firmly into the lamp cage compartment. [. . . ] Fasten the three-securing screws.
Close the lamp cage cover in the direction of the arrow (to the close mark) on the side of the projector. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE VOLTA 2855
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual VOLTA 2855 will begin.
