User manual VORTICE KRYO POLAR 12

[. . . ] 11 Table of Contents Before installing and using your product, read these instructions carefully. Vortice will not accept any responsibility for damage to property or personal harm resulting from failure to abide by the conditions listed below. Following these instructions will ensure long service life and overall electrical and mechanical reliability. Keep this instruction booklet in a safe place for reference purposes. [. . . ] 4) The hot air extraction hose supplied with the appliance can be extended by 300 to 1500 mm (figs 7, 8); It is best to use the smallest possible extension (fig. 7 36 cm 8 - Fit the rounded connector (13) to the end of the hose (10). - Insert the end of the hose into the hole in the panel (12). - If the panel is too big, cut it to fit the window. - Extract the hot air through the window or wall (fig. 6 ) 6 36 cm 9 - Fit the rounded connector (13) to the end of the extraction hose. - Make a hole (of more than 152 mm diameter) in the window or wall to accommodate the rounded connector. When the appliance is disconnected from the window or wall, use the blanking cap (14) to cover the hole. 14 ENGLISH Take care not to form kinks in the hose (fig. 10) where hot air could be trapped and then on escaping set off the automatic thermal cut-out system. Fitting the active carbon filters Remove the filter holder frame from the appliance (fig. The length of the hose has been carefully calculated to match the specifications of the appliance. You are advised not to replace the hose or extension as this may lead to a fault developing. Remove the filter fastening device from the frame (fig. 12) 12 Remove the filter from its packaging (fig. 13) 13 15 ENGLISH Insert the filter into the frame (fig. 15) 15 Functions Switching On/Off Press ON/OFF: the appliance comes on in Cooling Mode at minimum speed; the preset temperature is 24°C All the indicator lights come on at the same time; the display shows ambient temperature from 0°C to 50°C to turn the appliance off, press the ON/OFF button. Setting operating mode Press the MODE button to select the required operating mode: Fan, Dry, Cooling, Auto. The indicator light for the mode selected will come on. If the room temperature drops below the set limit, the Cooling Mode automatically cuts out and the appliance continues to operate in Fan Mode at the preset speed. If room temperature rises to above the preset limit, the appliance automatically goes back to Cooling Mode. Refit the filter holder to the appliance Function Control panel (fig. [. . . ] Needless to say, the drain must be at a lower level than the drain hole on the appliance. Should you opt for continuous drainage, the “condensation tank full” light is deactivated. 21 Maintenance/Cleaning Cleaning the appliance body N. Before starting any cleaning work, remove the plug from the main socket. [. . . ]