User manual VTECH BS 2652

[. . . ] Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use this product near water (for example, near a bath tub, kitchen sink, or swimming pool). [. . . ] You will hear a special tone when you reach the highest or lowest setting. Page/Intercom From Base to ALL Handsets: · To page all Handsets from the Base press the PAGE key. This will cause all Handsets linked with this Base to ring. · Each Handset will display GLOBAL CALL FROM BASE. · Any Handset can answer the page and enter intercom mode with the Base by pressing any key (except OFF and soft keys). 27 Advanced Operations From the Handset: During an active call press the VOL soft and soft key, then use the keys to adjust the earpiece volume. Handset and Base Operation · · · · To end an intercom call, press OFF on the Handset or PAGE on the Base. Press the Base PAGE key, then press the number of the Handset you want to call (e. g. Handset 2 can then answer the intercom call by pressing any key (except OFF and Softkeys). To end an intercom call press OFF on the Handset or PAGE (or SPEAKER) on the Base. The Base will ring once and then automatically enter intercom mode. To end an intercom call press OFF on the Handset or PAGE (or SPEAKER) on the Base. Press the INTERCOM key followed by the number of the other Handset you wish to call (e. g. Handset 3 can then answer the intercom call by pressing any key (except OFF or the Softkeys). To end the intercom call press OFF on either Handset. From Base to a particular Handset: From Handset to Base: · · · From Handset to Handset: · · Advanced Operations · Call ALL from Handset: · · · Press the INTERCOM key followed by will ring. *. All registered Handsets and the Base Any Handset can answer by pressing INTERCOM, or the Base can answer by pressing SPEAKER. To end the intercom call press OFF on Handset, or press SPEAKER on Base. Handsfree Speaker Operation Your 2652 Handset has a built-in handsfree speaker. This feature allows you to stand the Handset upright on a table or desktop and have handsfree conversations. For more information, refer to MAKING CALLS in HANDSET AND BASE OPERATION. To Switch Between Earpiece and Speaker While on a call you can press HANDSFREE to switch to speaker. While on a speaker call, press HANDSFREE again to the Handset earpiece. Base Speaker Operation The Base of your 2652 is equipped with a full duplex speaker. This is a very useful feature for handsfree conversations or conference calls at the Base Unit. For more information, refer to MAKING CALLS in HANDSET AND BASE OPERATION. 28 Handset and Base Operation Line in Use Indication On the Handset: When the telephone line is currently being used by a system Handset or the 2652 Base, a status message similar to this will display on idle Handset(s): When the telephone line is currently being used by a parallel set (a telephone device other than the 2652 on the same line) the phone icon will remain on steadily, and EXTENSION IN USE will be displayed. On the Base: When a system Handset or a 2652 Base is currently being used, the IN USE LED on the Base will illuminate steadily. When a parallel set is currently being used, the IN USE LED on the Base will flash. Low Battery Indication When a low battery is detected, the Battery icon will flash and a warning beep is played. The status message LOW BATTERY will also be displayed when the Handset is in idle mode. To prevent an unexpected call drop, a drained Handset battery should be replaced by a fully charged spare battery. 29 Advanced Operations Handset and Base Operation Conference Calling The 2652 is capable of supporting conference calls with up to two registered Handsets and the Base Unit. To enter a conference call, simply access the line with two or three extensions by pressing ON (or HANDSFREE) on the Handset or SPEAKER on the Base. [. . . ] If you have specially wired alarm dialing equipment connected to your telephone line, ensure the connection of this equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. Repair instructions If this equipment is malfunctioning, it must be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents. [. . . ]