User manual VTECH DS3211-2

[. . . ] User's manual w w w. v t e c h p h o n e s . c o m Model: DS3211-2 Congratulations on purchasing your new VTech product. Before using this telephone, please read the Important safety instructions on page 39 of this manual. This manual has all the feature operations and troubleshooting necessary to install and operate your new VTech telephone. [. . . ] No information is available about this caller. It is a long distance call. OR L (before the caller's number) 27 Appendix Handset display screen messages ALREADY SAVED CALL LOG EMPTY CALLING HANDSET X (for models with three or more handsets) CALLING OTHER HANDSET (for models with two handsets) CONNECTING. . . CHARGING DIRECTORY EMPTY ENDED HANDSET X IS CALLING (for models with three or more handsets) OTHER HANDSET IS CALLING (for models with two handsets) INCOMING CALL INTERCOM INTERCOM ENDED LINE IN USE LIST FULL LOW BATTERY MICROPHONE ON MUTED The telephone number entered is already stored in the directory. Calling another handset. The cordless handset is searching for the telephone base. The handset with low battery is recharging. Another system handset is calling. There is an incoming call. A system handset or another telephone on the same line is in use. MUTE is turned off and the person on the other end can hear you. You have turned off the handset microphone. The other party cannot hear you but you can hear the other party. There are new voicemail messages from your telephone company. NEW VOICEMAIL 28 Appendix Handset display screen messages NO LINE NO SIGNAL, CALL ENDED NOT AVAILABLE AT THIS TIME OUTSIDE CALL **PAGING** PHONE PLACE IN CHARGER RINGER MUTE SAVED SPEAKER UNABLE TO CALL TRY AGAIN There is no telephone line connected. Communication between handset and telephone base is lost during a call. One handset is already viewing the call log or directory and another handset attempts to review it. Connected to the external call during call transfer. The cordless handset locator is activated. Place the handset in the telephone base or charger for recharging. The ringer is muted temporarily during an incoming call. You have attempted to make an intercom call, but the handset you are calling is in the directory, in the call log, out of range or on an outside call. You are attempting to save a caller ID entry with no name or number. There are unreviewed calls in your call log. UNABLE TO SAVE XX MISSED CALLS 29 Appendix Handset and telephone base indicators Handset lights On when the handset speakerphone is in use. VOICEMAIL CHARGE Flashes when you have new voicemail from your telephone company. On when the handset is charging in the telephone base or charger. Telephone base lights IN USE Flashes when there is an incoming call or another telephone sharing the same line is in use. Flashes when you have new voicemail from your telephone company. VOICEMAIL Handset icons Cycles (low, medium, and full) when the handset battery is charging. [. . . ] If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. If this equipment is malfunctioning, it must be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents. For repair procedures, follow the instructions outlined under the Limited Warranty. 44 Appendix FCC, ACTA and IC regulations If this equipment is causing harm to the telephone network, the telephone company may temporarily discontinue your telephone service. [. . . ]