User manual VTECH IA5859

[. . . ] Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use this product near water (for example, near a bath tub, kitchen sink or swimming pool). [. . . ] Press SELECT until the system announces the correct hour, then press TIME/SET. Press SELECT until the system announces the correct minute, then press TIME/SET. Press SELECT until the system announces the correct year, then press TIME/ SET. The system announces the current clock setting. You can set the time manually, or allow it to be set automatically with incoming caller ID information. (This only applies if you subscribe to CID service provided by your local telephone company. ) 2. To advance the minutes or years by increments of 10, press and hold SELECT. 2. Basic Operation About Mailboxes This answering system has three voice mailboxes. Callers using a touch tone phone can select the mailbox in which their messages will be recorded by pressing 1, 2 or 3. If the caller does not select a specific mailbox, their message will be recorded in Mailbox 1. About Announcements · · · · You can record two different announcements -- one for normal answering and one for when you've set the system to play an announcement only. Use normal answering when you want the system to record callers' messages. Use announce only when you want to give information to callers without accepting messages. If you choose not to record an announcement, the system answers with a pre-recorded announcement. The normal answering pre-recorded announcement says: "Hello. I'm unable to answer your call right now. Please leave your name, number and a message after the tone. " The announce only pre-recorded announcement says: "Hello, I'm unable to answer your call right now. Thank you. " By setting announce only to ON or OFF, you decide which announcement your callers will hear when the system answers a call (the system comes set 22 · Answering System Operation for normal answering, with announce only turned OFF). See Set Announce Only, located in the Feature Summary chart later in this section, to change your announcement selection. Select a feature setting Enter feature setup and select features to set. . . . . Record outgoing announcements and memos. Delete outgoing announcements, messages and memos Record Your Announcement If you have assigned different mailboxes to different people, be sure to tell callers in your announcement to press 1 , 2, or 3 to leave a message in the appropriate mailbox. For example: "Thank you for calling. To leave a message for Bob, press 1 now. To leave a message for Sue, press 2 now. [. . . ] It does not imply that Industry Canada approved the equipment. Notice: The Ringer Equivalence Number (REN) for this terminal equipment is 0. 1. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. [. . . ]