User manual VTECH T 2426

[. . . ] IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: Read and understand all instructions. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. [. . . ] 4 Press SELECT three times to store the call record in memory without editing. Choose Y (for Yes) if you wish the phone to alert you to calls from this number by changing to a distinctive ringing pattern after the first ring. Choose N (for No) for a normal ringing pattern. 6 Press SELECT or PROG/CHAN to confirm your selection. If you chose Y, a D will be displayed with the directory entry. Display Screen Messages 17 BASIC OPERATION The phone number will be displayed in the format it was received. 4 Press SELECT when the number is correctly displayed for dialing. -ORWhen the number is correctly for dialing, press PHONE. BATTERIES Battery Care and Maintenance · This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about six hours. · The battery pack needs charging when: -- A new battery is installed in the Handset. -- The phone beeps twice every 5 seconds. -- The screen displays BATTERY LOW and the low battery icon. · Place the Handset in the Base so the CHARGING light turns on. The battery pack is typically fully charged in eight hours. · You can keep the battery fully charged by returning the Handset to the Base after each use. · If you repeatedly get a low battery indicator, even after charging overnight, the battery should be replaced. CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully: Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in this User's Manual. Replacing the Handset Battery Pack 1 Remove the battery compartment cover on the Handset by pressing on the indentation and sliding the cover downward. 2 Lift out the old battery pack and disconnect. 3 Align the two holes in the new battery pack's plug with the socket pins, and snap the plug into place. Place the battery pack in the compartment with the wires in the lower left corner, along the bottom of the battery pack. 4 Replace the cover by sliding it up into place. 5 The new battery pack must be charged before using the phone. [. . . ] · Programming/testing of emergency numbers should be performed during off-peak hours, such as in the early morning or late evening, when the emergency services tend to be less busy. IC (Industry Canada) This telephone is registered for use in Canada. The term "IC:" before the radio certification number only signifies that Industry Canada technical specifications were met. Notice: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. [. . . ]