User manual VTECH VT 1711

[. . . ] USER'S MANUAL 900MHZ DIGITAL SPREAD SPECTRUM CORDLESS TELEPHONE INTRODUCTION Parts Check List 1. Belt Clip To purchase replacement battery packs, call VTECH Communications at 1-800-5959511. In Canada, call VTECH Electronics at 1-800-267-7377. VT 1711 10 9 8 7 6 5 4 3 2 1 MEM 12 ORY DIA 11 LI 20 19 18 17 16 15 14 13 NG CH spar e ba tte AR PO WER hand set in-u se GIN G ry PA GE D CO IGIT SP RDLE AL REA SS D SP EC M VT TRUM HZ 1711 900 Handset Base Unit VTECH Belt Clip Wall mount accessory Telephone Cord I M P O R TA N T BEFORE USING YOUR NEW PHONE, WE STRONGLY RECOMMEN D YOU READ THIS MANUAL THOROUGHLY. Battery Pack AC Adaptor 1 VTECH COMMUNICATIONS LTD. Made in China 91-5033-13-00 FCC AND IC REGULATIONS This equipment complies with Parts 15 and 68 of the Federal Communications Commission (FCC) rules for the United States. [. . . ] If you make a mistake when dialing, press ON/OFF to hang up, then press the ON/ OFF key to get the dial tone again. DISCONNECTING To end a call, either place the handset back in the Base Unit, or press ON/OFF. VOLUME CONTROLS The volume controls for the handset are located on the side of the unit. Press the or key to increase or decrease the volume. While on an active call, holding either key down will continually change the volume setting. The earpiece volume level will change accordingly. flash You can use your VTech VT1711 cordless phone with services such as Call Waiting. REDIAL To REDIAL the last number you dialed, press the ON/OFF key, then press REDIAL. The phone will automatically dial the number. HOLD Press HOLD to place an active call on hold. The PHONE LED will flash to indicate call is on hold. Press ON/OFF or HOLD again to return to the call. If a call is on Hold using VT1711 and the user picks up another phone on the same link, the VT1711 will take itself off hold and turn off. therefore, you do not have to go back to turn the phone off if you go to another extension. To cancel the page, either press PAGE again on the base or press ON/OFF on the handset. ADVANCED FUNCTIONS TEMPORARY TONE If you have rotary (dial-pulse) telephone service (TONE/PULSE switch is set to PULSE), this feature allows you to temporarily switch to TONE dialing for such purposes as remote access to answering machines, bank-by-phone services, use of calling cards and other special services. Then activate the Temporar y Tone (TONE key). You can then press the numbers or symbols you need, and your phone will send the proper tones. * Press FLASH * Press: 1 for ringer type 1 2 for ringer type 2 3 for ringer type 3 4 for ringer type 4 BASIC OPERATION * The handset must be OFF. * Enter the two digit memory location that you wish to delete (01. . 20). * The phone will emit two short beeps and exit programming mode. NOTE:Stored numbers are retained in memory even if the base loses its power or the handset battery is removed. [. . . ] * Include payment for any service or repair not covered by warranty, as determined by VTECH Communications. * Ship the unit via UPS Insured, or equivalent to: VTECH COMMUNICATIONS 11035 SW 11th STREET BLDG. B SUITE 270 BEAVERTON, OR 97005 In Canada VTECH ELECTRONICS SUITE 2007671 Alderbridge Way Richmord, B. C. U6X 1Z9 VTECH Communications assumes no responsibility for units sent without prior Return Authorization. [. . . ]