User manual VTECH VT 9241

[. . . ] You have purchased one of the best performing cordless telephones on the market!The VT 9241 is a two line 900 MHz cordless phone with Speakerphone & secondary keypad on the Base Unit. · 10 Number Speed Dial Memory (20 digits each). · Automatic Search for clear channel. [. . . ] Speak towards the microphone on the front edge of the Base Unit. 17 OPERATING INSTRUCTIONS To return to the phone call, press the appropriate LINE key on Base or Handset. IF YOUR PHONE RINGS DURING AN INTERCOM CONVERSATION If you receive a call while using the Intercom, the Base will only ring once, and the Handset will generate 3 alerting tones through the earpiece. The LINE key will flash on both Base and Handset. You can answer the incoming call by pressing the LINE key of the ringing line on the Base or Handset. However, by answering the incoming call you will automatically exit the Intercom mode. USING THE INTERCOM DURING A PHONE CALL The HOLD feature allows you to put a phone call on hold and use the Intercom without disconnecting your caller. While you are on the call on the Handset, press the INT. COM key to automatically place the active call on hold, and to establish an Intercom call between the Handset and Base. press INT. COM/PAGE on the Base to page the Handset. Then press INT. COM on the Handset to enter Intercom mode. To end the Intercom conversation, press OFF on either the Handset or OFF on the Base Unit. To return to the call, press the appropriate LINE key on the Handset or Base. TEMPORARY TONE FEATURE If you have rotary (dial-pulse) telephone service, (TONE/PULSE switch is set to PULSE), this feature allows you to enter special codes and tones to operate answering machines, use electronic banking services, calling cards, or other special services. Activate the temporary tone feature by pressing TONE (the key). Press the numbers or symbols you need, and your phone will send the proper signals. This feature is available on both the Handset and the Base Unit. INT. COM * TONE 0OPER CHAN HOLD PGM MEM CONF REDIAL PAUSE To end the call, press OFF . The phone will automatically go back to rotary (dial-pulse) service. While you are on the call on the Base Unit, press HOLD and then 18 The VT 9241 features four different Handset ringer types for each line. OPERATING INSTRUCTIONS To program, The Handset must be OFF. To select a different ringer type do the following: TONE 3. Press the OFF key to exit 0OPER CHAN INT. COM HOLD To turn off the ringer on the Base Unit set the RINGER switch to OFF. CHECKING THE RINGER To check the Handset ringer which is currently programmed do the following: PGM MEM CONF REDIAL PAUSE 1. Press the # key 7PQRS TONE 8TUV 0OPER CHAN 9WXYZ 3. Press a key 1. . 4 to select a ringer type The VT 9241 will ring once to show the type of ringer selected. [. . . ] The general rule is that the REN value should not exceed 5. 0 total; however, contact your local telephone company for the specific number in your area. IC (Industry Canada) This telephone is registered for use in Canada. Notice: The Ringer Equivalence Number (REN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading. The termination of a loop may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalent Numbers of all devices not exceed 5. 0. [. . . ]