User manual VTECH VT 9111

[. . . ] INTRODUCTION USER'S MANUAL VTECH V T 9 1 1 1 / V T 9 1 1 5 900MHz ANALOG CORDLESS TELEPHONE Parts Check List: 1. Wall mounting bracket HANDSET BASE UNIT IMPORTANT BEFORE USING YOUR NEW PHONE, WE STRONGLY RECOMMEND YOU READ THIS MANUAL THOROUGHLY. TELEPHONE LINE CORD AC ADAPTER VTECH COMMUNICATIONS LTD. Copyright 1998 for VTECH COMMUNICATIONS LTD. ISSUE 0 91-5017-32-00 BATTERY PACK 1 WALL MOUNT BRACKET IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. [. . . ] The IN USE LED on the base unit will flash during the initialization. Making Calls Pick up the handset and press PHONE. When you hear a dial tone, dial the number. The indicator for IN USE (on the base unit and handset) will light. If you make a mistake when dialing, press OFF to hang up, then press PHONE to get the dial tone again. You must always press PHONE before you can dial a call on the handset. Answering Calls When an incoming call is ringing, the IN USE LED on the base and PHONE LED on the handset will flash. To make sure your phone rings when the handset is away from the base, please keep the base antenna in the upright position. To answer a call when the handset is in the base, just pick up the handset. To answer a call when the handset is away from the base, just press any key on the handset (except OFF). This is very useful in a dark environment; you do not have to fumble around looking for the PHONE key to answer the call. OPERATING INSTRUCTIONS Disconnecting To end a call, either place the handset back in the base, or press OFF on the handset. Changing Channels If you notice interference when using your handset, press CHAN to switch to a clear channel. This function is only available when you are on a call. 9 IN USE LED VOLUME SWITCH PHONE KEY OFF KEY CHAN KEY CHARGING LED IN USE LED POWER LED TONE/ KEY PROG KEY MEM KEY REDIAL KEY PAGE KEY 8 OPERATING INSTRUCTIONS To Change or Replace a Speed Dial Number To change or replace a stored number in speed dial memory simply enter the new number and store it in the memory location you wish to change. For example, to change the number stored in memory position 7 to 555-1111, you would press PROG, 7, 555-1111, MEM. Storing Pauses in Memory To insert a pause in a phone number, press and hold the number before the position where the pause is to be inserted. Hold the number key down until it beeps twice. For longer pauses, press and hold the key until it beeps three or four times. Each additional beep indicates an additional 2 second pause. If your phone is connected to a PBX you can store the PBX access number and a pause before the phone number. For example, to store 9-PAUSE-555-1234 in memory location 8 do the following: 10 1. Press and hold 9 until it beeps at least twice. [. . . ] Your telephone company may discontinue your service if your equipment causes harm to the telephone network. They will notify you in advance of disconnection, if possible. During notification, you will be informed of your right to file a complaint with the FCC. If it is determined that your telephone equipment is malfunctioning, the FCC requires that it not be used and that it be unplugged from the modular jack until the problem has been corrected. [. . . ]