User manual VTECH VT2428

[. . . ] CONTENTS Important Safety Instructions. . . . . . . . . . . . 1 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . 2 About Caller Identification . . . . . . . . . . . . . . . . . 2 Parts Check List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Before You Install . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Table/Desk Installation . . . . . . . . . . . . . . . . . . . . . [. . . ] 3 Press or until ALL flashes, then press SELECT. The current choice flashes. 13 CALLER ID OPERATION 4 Press or until YES flashes. You will hear a series of beeps confirming the deletion. NOTE: If there are new CID records not yet reviewed , the " ALL" option will not be displayed as a selection. Dial a Displayed Number 1 Locate the record in call history that you want to dial. 2 If you wish to change how the number is dialed, press # . The screen displays any alternate dialing sequences available for this call (area code + number; 1 + area code + number; 1+ number; number only). 3 Press SELECT, then press or until DIAL flashes. The phone number will be displayed in the format it was received. 4 Press SELECT when the number is correctly displayed for dialing. Store a Call History Record in the Directory 1 Locate the record in call history you want to store in memory. 2 If you wish to change how the number is stored, press # . The screen displays any alternate dialing sequences available for this call (area code + number; 1 + area code + number; 1+ number; number only). 3 Press SELECT, then press The phone number will be displayed in the format it was received. 4 Press SELECT four times to store the call record in memory. You'll hear a beep confirming that the name number were stored. Display Screen Messages 14 BATTERIES Charge the Handset Battery Pack · This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about six hours. · The battery pack needs charging when: -- A new battery is installed in the handset. -- The phone beeps twice every 5 seconds. -- The screen displays BATTERY LOW and the low battery icon. · Place the handset in the base so the CHARGING light turns on. The battery pack is typically fully charged in eight hours. · You can keep the battery fully charged by returning the handset to the base after each use. [. . . ] IC (Industry Canada) This telephone is registered for use in Canada. Notice : The REN assigned to this device denotes the number of devices you may connect to the telephone loop which is used by the device to prevent overloading The termination on a loop may consist of any combination of devices subjected only to the requirement that the sum of the REN does not exceed five (5. 0) Notice : The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfaction. [. . . ]