User manual VTECH VZ2655

[. . . ] Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use this product near water (for example, near a bath tub, kitchen sink, or swimming pool). [. . . ] · The Base will ring once and then automatically enter intercom mode. · To end an intercom call press OFF on the Handset or PAGE (or SPEAKER) on the Base. From Handset to Handset: · Press the INTERCOM key followed by the number of the other Handset you wish to call (e. g. · Handset 3 can then answer the intercom call by pressing any key (except OFF and Softkey). · To end the intercom call press OFF on either Handset. 25 Advanced Operations Handset and Base Operation Call ALL from Handset: · Press the INTERCOM key followed by the *. All registered Handsets and the Base will ring. · Any Handset can answer by pressing INTERCOM, or the Base can answer by pressing SPEAKER. · To end the intercom call press OFF on Handset, or press SPEAKER on Base. Handsfree Speaker Operation Your 2655 Handset has a built-in handsfree speaker. This feature allows you to stand the Handset upright on a table or desktop and have handsfree conversations. For more information, refer to MAKING CALLS in HANDSET AND BASE OPERATION. To Switch Between Earpiece and Speaker While on a call you can press HANDSFREE to switch to speaker. While on a speaker call, press HANDSFREE again to the Handset earpiece. Advanced Operations 26 Handset and Base Operation Base Speaker Operation The Base of your 2652 is equipped with a full duplex speaker. This is a very useful feature for handsfree conversations or conference calls at the Base Unit. For more information, refer to MAKING CALLS in the HANDSET AND BASE OPERATION section. Line in Use Indication On the Handset: When the telephone line is currently being used by a system Handset or the Base, a status message similar to this will display on idle Handset(s): When a system Handset or a Base is currently being used, the IN USE LED on the Base will illuminate steadily. When a parallel set is currently being used, the IN USE LED on the Base will flash. Low Battery Indication When a low battery is detected, the Battery icon will flash and a warning beep is played. The status message LOW BATTERY will also be displayed when the Handset is in idle mode. To prevent an unexpected call drop, a drained Handset battery should be replaced by a fully charged spare battery. 27 Advanced Operations When the telephone line is currently being used by a parallel set (a telephone device other than the 2655 on the same line) the phone icon will remain on steadily, and EXTENSION IN USE will be displayed. On the Base: Handset and Base Operation Conference Calling The 2655 is capable of supporting conference calls between the two registered Handsets and the Base Unit. To enter a conference call, simply access the line with two or three extensions by pressing ON (or HANDSFREE) on the Handset or SPEAKER on the Base. The phone icon and two or three extension numbers will be displayed in the upper left corner of the Handset. Transferring Calls You can transfer calls on the 2655 system from the Base to Handset, Handset to Handset, or Handset to Base. Blind Transfer You can directly transfer any active call to another system extension without notification by doing the following steps: · Handset or Base must be on an active call. · Press the INTERCOM key on the handset or PAGE key on the base followed by the number of the Handset (1 or 2) or Base (0) that you wish to transfer the call to. When the other extension answers, the call will automatically be connected to the other extension. [. . . ] The telephone company is required to notify you before interrupting service. If advance notice is not practical, you will be notified as soon as possible. You will be given the opportunity to correct the problem and the telephone company is required to inform you of your right to file a complaint with the FCC. Your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the proper functioning of this product. [. . . ]