User manual WACOM DTU-1631

[. . . ] Contents Index 1 USER'S MANUAL Interactive pen display Model: DTU-2231, DTU-1631 Interactive pen display Installation Using the pen Customizing the pen Using the pen display Customizing the pen display Using the Radial Menu Application-specific settings Troubleshooting Contents Index 1 Interactive pen display Contents Index 2 Interactive pen display User's Manual Version 2. 0, Rev A2510 Copyright © Wacom Co. , Ltd. , 2010 All rights reserved. No part of this manual may be reproduced except for your express personal use. Wacom reserves the right to revise this publication without obligation to provide notification of such changes. Wacom does its best to provide current and accurate information in this manual. [. . . ] Note: When testing your pen buttons, if a button is set to RADIAL MENU or OPEN/RUN. . . , that function will occur when the button is pressed. In this case you may want to change that button's function before testing. While observing the POINTING DEVICE INFO column, bring your pen within 5 mm (0. 2 inch) of the display screen. A value for PROXIMITY, the DEVICE NAME, and DEVICE TYPE should be displayed. Move your tool along the pen display screen surface. The X and Y Data values should change to reflect the tool position. The pen display status LED should light blue each time you click with the pen tip, press the side switch, or press the pen eraser to the display screen. · Press on the display screen surface with the pen tip. The SWITCHES state and PRESSURE value should change. (PRESSURE should change from approximately 0% with no pressure applied to approximately 100% when full pressure is applied. ) Next, press the side switch without pressing the tip to the display screen surface. Do this for both positions of the DuoSwitch. Tip = 1, DuoSwitch (lower position) = 2, DuoSwitch (upper position) = 3, Eraser = 1 · · Press the pen eraser to the display screen. The SWITCHES state and PRESSURE value should change. (PRESSURE should change from approximately 0% with no pressure applied to approximately 100% when full pressure is applied. ) 4. When you are done, click on the CLOSE button to exit the dialog box. Contents Index 47 Interactive pen display Contents Index 48 DISPLAY TROUBLESHOOTING If you encounter problems with the display portion of the interactive pen display, refer to the following tables; your problem may be described here and you can try the solution offered. For additional information about color issues, see the documentation that came with your operating system or applications. General display problems VGA problems GENERAL DISPLAY PROBLEMS No display. A `no signal go to power save' message appears briefly on your display screen. Verify that the AC power cable is connected, and that the pen display power switch is turned on. Check the contrast, brightness, and backlight controls. Or, open the OSD menu and select the RESET option. · Your computer may be in a power management mode. Touch the pen tip to the display screen, move the mouse, or depress any key on your keyboard. [. . . ] Wherever you place your pen on the interactive pen display, the screen cursor will jump to the corresponding point on the screen. This is known as absolute positioning, and is the default setting for the pen. Also, pen mode allows you to quickly position the screen cursor without having to first find it and then move it across the desktop. The smallest unit of measure on your display screen. [. . . ]