User manual WANDERS NORMANDIE

[. . . ] The outer pipe extracts fresh air which produces beautiful and evenly burning flames. In principle, your gas unit can be installed in all kinds of spaces, even in rooms without any ventilation or with mechanical ventilation. When designing this fireplace we took particular care of the ease of use, the safety and the design. Your gas unit is developed and produced at our own factory in Netterden (the Netherlands) and is for the greater part handmade. [. . . ] if the TIMER mode is switched on , the temperature control will be the same as in the AUTO position. You can switch off the TIMER mode with the and buttons. the remote control will automatically switch to the MAN function. MAN When the display shows the MAN position you can manually turn the hearth higher and lower by using the big buttons. When you press and hold the button the hearth will go to its lowest position: the pilot flame. When you keep these buttons pressed, you will see the `transmit' symbol top left in the display. You will know when the hearth has reached its highest or lowest position when the LED of the receiver starts blinking. Place some pieces of ceramic bark exactly as shown in the illustrations. Start with four pieces of bark on the burner but do not block the outflow passage of the pilot. Make sure there is no log or stone in front of the pilot as this may prevent the main burner from ignition whereby unburnt gas may accumulate in the stove. If this happens, you must extinguish the pilot and notify your installer. Every gas hearth by WANDERS is installed with a thermocouple interrupter. This will prevent unexpected gas flow if the pilot light has gone out. Here are some recommendations for safely using your gas hearth: 1. Only use your gas hearth when the door is properly closed. When the door is open, or the glass damaged, you must not use the fireplace. Prevent small children or the infirm from getting too close to a burning stove and do not leave them alone in the room when the fireplace is ignited. Turn the ignition knob all the way to the symbol of the small flame to deactivate the remote control while the pilot flame stays on. This is to ensure that nobody can accidentally change the temperature of your hearth. Never allow children to play with the remote handset. Do not pour or put any combustible liquids and materials on the log set, as it may damage the unit beyond repair. The gas hearth must never be built in the wall. [. . . ] To install the insert model one needs to remove the 4 attached strips on each corner. Unscrew the three screws which hold the strip · remove the strips · Place the screws back in their initial position For natural gas: With 1 metre vertical and wall duct of Ø 70 mm With 1 metre vertical and 1, 2 or 3 metres vertical: no pipe closer With a roof duct without bend you must place: · A pipe closer of Ø 50 mm from 2 to 4 metres · A pipe closer of Ø 40 mm from 5 to 10 metres Place the pipe closer by screwing it on the inside below the mouth of the pipe. For propane With a wall duct: no pipe closer With a roof duct without bend you must place: · A pipe closer of Ø 50 mm from 2 to 4 metres · A pipe closer of Ø 40 mm from 5 to 10 metres Place the pipe closer by screwing it on the inside below the mouth of the pipe. With your fingers when you replace the pane. [. . . ]