User manual WAVECOM SPL 8028X

[. . . ] When displaying 99% the memory is full and all 4096 pages of memory are used. The unit will need to be downloaded and cleared prior to logging more data. The average period is the time interval the sampling is average over. The unit collects the data for say 5 minutes (as shown in above Sample) and averages all temporary accumulated data and stores the averaged value with date and time stamp. [. . . ] To reset these values to zero the user must Reset MAX & MIN Values in setup Menu. DWN Date and Time 06 02 2000 13:43 This Display shows the user what the real time is set too. The Setup Menu or PC can altar the Date and Time. The Time will only update every minute although the system measures and stamps recordings including seconds. DWN 12kWh 0kVAh 50. 0Hz This Display shows the user what the power usage is upto the second reading. The Frequency is also displayed real time. DWN Using the DWN Key again will bring the user to the MAIN DISPLAY screen completing the Display Data Loop. User Manual ­ SPL 8028X 7 SETUP MENU MEN Pressing the menu key enables the user to toggle between the MAIN DISPLAY and SETUP MENU DISPLAY. KEY Setup Logger?No, Press Menu Pressing the MENU key twice is not required. If pressed once Press key and the display will not locked. If Keyboard Locked will acknowledge the setup menu the above display will be displayed. ask for confirmation if keyboard is See Lock Unlock Key board. ENT Setup Logger?Confirm? Press to confirm Setup menu. ENT SPL Setup Mode Use Up and Down wishes to get to and Change. Once in this mode and left without any keystrokes for 2 minutes the SPL will change back to the MAIN DISPLAY screen resetting into normal operation mode. Using DWN the Key the menu flows as following. This prompts the user to use the Up and DWN Keys to select function the User Change Amps Mode Enter, Up or Dwn Press ENT to confirm Setup menu. Amps Input 1A Use Up and Dwn Pressing UP or DWN Key will give the Choice of 3 settings 1A, 5A, 200mV Amps Input 5A Use Up and Dwn Amps Input 200mV Use Up and Dwn 8 User Manual ­ SPL 8028X Select input option required ENT press to confirm selection. Amps Input 5A Done! The Flash screen confirms the entry with DONE!Then resets to the top of setup menu allowing user to change the next setting or Pressing menu to opt back to logging /MAIN DISPLAY by Pressing MENU button. Set Amps Ratio?Enter, Up or Dwn ENT Set Amps Ratio?Confirm? ENT Pressing UP or DWN Key will give the Choice of 24 Ratio settings. 1, 2, 5, 10, 12, 20, 26, 30, 32, 40, 50, 100, 105, 150, 200, 240, 320, 400, 500, 600, 700, 800, 900, 1 000. Select input option required press ENT to confirm selection. Amps Ratio 20 Done! The Flash screen confirms the entry with DONE!Then resets to the top of setup menu allowing user to change the next setting or Pressing menu to opt back to logging /MAIN DISPLAY by Pressing MENU button. [. . . ] Holding the Up or DWN key for 1 sec will enable fast scrolling. User Manual ­ SPL 8028X 10 Calibration Software Setup Install CD into drive select "RUN" from the "Start Menu" selection bar. Select SPL D:\disks\setup. exe to begin installation. (D: Drive being your CD. ) When prompted install program into desired directory or folder. Create new name of file or folder if you wish. Follow prompts to complete installation. [. . . ]