User manual WAVES GTR

[. . . ] Waves Guitar Tool Rack Designed in association with Paul Reed SmithTM Guitars THANK YOU! Thank you for purchasing the Waves GTRTM system. We hope that you thoroughly enjoy the creativity and convenience that this can bring to your music. Please read through the information below and begin working with your new GTRTM system. If you have any questions or comments, please feel free to contact Waves Tech Support. [. . . ] Hot and spicy, it comes in Mono and Stereo Channel configurations. The Distortion Stomp offers 4 controls: DRIVE: 0 ­ 100; Default: 50 Drive sets the amount of distortion driven over the input signal. The drive control is a loudness normalized control that allows you to hear the amount of drive without an extreme boost in level. LEVEL: 0 ­ 100; Default: 50 This sets the output level. Setting level to 50 is designed to maintain loudness compared to bypass. CONTOUR: 0 ­ 100; Default: 50 Contour sets the fullness and body of the distortion. Low values make for a thinner sound that will cut through anything, while high values drive on a fuller bodied and warmer sound. This is the Cutoff of the Output Filter Range. Waves Guitar Tool Rack User Guide. 25 FUZZ Fuzz is a classic distortion effect that's been popular since the `60's. Big and brutal, it's terrific for solo licks and riffs as well as muted low string power chords. Available in Mono and Stereo, the Fuzz offers 3 controls: SUSTAIN: 0 ­ 100; Default 50 Similar to the Drive control in the previous Stomps, this will ultimately give your fuzz sound longer sustain. LEVEL: 0 ­ 100; Default: 50 This control will boost or pad the output level of the Fuzz. TONE: 0 ­ 100; Default: 50 The Fuzz offers a Tone control that goes from a low pass, bass boost into a high pass treble boosted fuzz sound. Some users will go for the extremes but the whole range is valuable. Waves Guitar Tool Rack User Guide. 26 BUZZ Buzz offers a unique tone with a resonant peak at the high pass cutoff frequency. Using an expression pedal to control the tone transforms Buzz into a distortion/wah-wah hybrid. It has the following controls: DRIVE: 0 ­ 100; Default 50 Drive sets the amount of distortion driven over the input signal. The drive control is a loudness normalized control that allows you to hear the amount of drive without extreme level boost. TONE: 0 ­ 100; Default 50 Tone controls the resonant low pass filter cutoff. LEVEL: 0 ­ 100; Default 50 This sets the output level of the effect. 50 is a good neutral value compared to the direct bypass loudness. Waves Guitar Tool Rack User Guide. 27 METAL The Metal Stomp has a dual distortion engine which can be driven very hard while maintaining resolution for chords and solos. The Metal Stomp offers enhanced EQ control offering a full set of Low, Mid and High tone controls with a variable cutoff for the mid bell filter. If you need to go beyond what the other distortion Stomps have to offer, this is it. The Metal tone controls are: DIST: 0 ­ 100; Default 50 Dist controls the amount of distortion effect. [. . . ] OUTPUT UNBALANCED ¼' (TRS): *All measurements were preformed with volume at a nominal setting. Output impedance: 100 ohms S/N: >105 @ line level, (S measured at 1%, 1 Khz, A Weighted) Response: 20-20Khz, -3dB @11Khz, -5dB @ 20Khz THD+N: <0. 005 (< -90dB) @ -10dB below max sensitivity level Sensitivity: 1. 1Vrms @ line level, 2. 5 Vrms @ mic Level Gain: 5dB @ line level, ±1dB Volume range: +5dB, -10dB refer to nominal setting Power supply: Power on/off switch Dual 9V battery 12-18V DC, Nominal 60mA±10% Low Batt indicator: Blink @ 7V±0. 5V Power saving switch: Automatic shut down when input ¼" jack is not connected Level indicator: Green LED ­ On @ 15mV rms input signal Yellow LED ­ On @ 100mVrms input signal Red LED ­ On @ 1. 1Vrms input signal Dimensions: Length: 11. 5 cm, Width: 9. 5 cm, Height: 4. 3 cm, Weight: 356 gr. Waves Guitar Tool Rack User Guide. 59 Warranty ONE YEAR LIMITED WARRANTY Waves Audio Ltd. ("Waves") warrants that the Product conforms substantially to the specifications contained in the Product documentation for a period of one (1) year from the date of original purchase from Waves or its authorized resellers. In the case of a valid warranty claim, your sole and exclusive remedy and Waves' entire liability under any theory of liability will be, at its option, to repair or replace the Product without charge or, if this is not possible, to refund the purchase price to you. [. . . ]