User manual WEED EATER BC3100

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Operator's Manual Manual del Operador Manuel de l'utilisateur ESPAÑOL BC3100 UL R DANGER: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] Be sure to store parts and instructions for future use. FUEL YOUR UNIT This engine is certified to operate on unleaded gasoline. Gasoline must be mixed with a good quality 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand oil is recommended. (A 40:1 ratio is obtained by mixing 3. 2 ounces of oil with 1 gallon of unleaded gasoline). When mixing fuel follow the instructions printed on the container. Always read and follow the safety rules under FUEL SAFETY. Shield Dust Cup Threaded Shaft STARTING STOPPING YOUR ENGINE Retaining Washer Cupped Washer Nut Blade S Move the ON/STOP switch to the STOP position. S If engine does not stop, move choke to the FULL CHOKE position. On/Stop Switch Throttle Trigger On Stop STARTING YOUR ENGINE WARNING: Do not use any blades, or fastening hardware other than the washers and nuts illustrated. These parts must be provided by Weed Eater, and installed as shown below. Failure to use proper parts can cause the blade to fly off and seriously hurt you or others. NOTE: Make sure all parts are in place as illustrated, and the blade is sandwiched between the dust cup and the retaining washer. There should be no space between the blade and the dust cup or the retaining washer. S Align hole in the dust cup with the hole in the side of the gearbox by rotating the blade. S Insert a hex wrench into the aligned holes. This will keep the shaft from turning while tightening the blade nut. Hex Wrench WARNING: The blade or trimmer head will turn while starting the engine. NOTE: A special feature called the "Throttle Lock" holds the throttle trigger in the depressed position during starting. S Lock throttle trigger into the starting position by first pressing the lock--out lever on the top of the control handle. While the lock--out lever is depressed, squeeze and hold the throttle trigger. Lock Button Lock--out Lever Throttle Trigger S Before releasing the throttle trigger, press the lock button. While this button is still depressed release the throttle trigger. NOTE: This should allow the throttle trigger to remain in the depressed position for starting. You may want to practice this a few times before you first start the unit. [. . . ] Expenses covered under warranty include diagnosis, parts and labor. MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by POULAN/WEED EATER. OWNER'S WARRANTY RESPONSIBILITIES: As the lawn and garden equipment engine owner, you are responsible for the performance of the required maintenance listed in your Owner's Manual. POULAN/WEED EATER recommends that you retain all receipts covering maintenance on your lawn and garden equipment engine, but POULAN/WEED EATER cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. [. . . ]