User manual WEED EATER EBV200W

[. . . ] ENGLISH R Trademark Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l'outil au détaillant. 1-800-554-6723 www. weedeater. com Instruction Manual Manual de Instrucciones Manuel d'Instructions EBV 200W FOR HOUSEHOLD USE ONLY PARA USO CASERO SOLAMENTE POUR UTILISATION À DES FINS DOMESTIQUES SEULEMENT WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury. [. . . ] The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades. S Hard objects can be thrown through the collection bag or the housing and become dangerous missiles which can cause serious injury to the operator or others. S When using the vacuum attachment, the unit is designed to pick up dry material such as leaves, grass, small twigs, and bits of paper. Do not vacuum stones, gravel, metal, broken glass, etc. , to avoid severe damage to the impeller. To avoid the possibility of electrical shock, do not attempt to vacuum water or other liquids. S Never run the unit without the proper equipment attached. When used as a vacuum, always install vacuum tubes and collection bag assembly. Make sure the collection bag assembly is completely zipped when unit is running to avoid flying debris. S Avoid situations which could set the collection bag on fire. You will next attach the vacuum tubes. Vacuum Inlet Cover To attach blower tube: 1. Align the grooves on the blower tube with the grooves on the blower outlet. Push the blower tube onto the blower outlet until it snaps into place (tube is secured by red tube release button). To remove the blower tube, press the tube release button while pulling on tube. Tube Release Button Blower Tube Blower outlet Inlet Restrictor VACUUM ASSEMBLY NOTE: Assembly instructions for using your unit as a blower are explained in the previous section. If you have already assembled your unit for use as a blower, remove the blower tube. Remove the inlet restrictor An inlet restrictor is used when using your unit as a blower. This restrictor is not used during vacuum use and must be removed during assembly for vacuum use. NOTE: Be sure to keep the inlet restrictor for using your unit as a blower. Ensure unit is stopped and extension cord is unplugged. Open the inlet cover by inserting the tip of a screwdriver into the latch area on the blower unit. Gently tilt handle Attaching the vacuum tubes There are 2 vacuum tubes, an upper tube and a lower tube. The upper tube has a vacuum assist handle attached to one end and is cut straight on both ends. The upper tube attaches to the blower unit. [. . . ] The inlet cover must be held open through all remaining steps. Carefully reach into the vacuum opening and clear out the air intake area. If cracked or damaged, do not use the unit. Have parts replaced by your authorized service dealer. [. . . ]